Good day to all, I´ve been researching the group site on the topic of isolation of this engine to Amel specs. I did find the file of the schematics for this job, which will give some clues, and grateful it even exists. However, I don´t seem to find any conclusions or complete instructions to carry out this job. Does Amel sell this kit?

We re powered our Maramu in 2013 with this engine because of the opportunity we found and it works fine, but now I very concerned with the isolation issues, since now it is not isolated and cannot imagine the consequences of not doing so. So far, there are no symptoms of corrosion. We do not have a C drive but an ordinary shaft, so it is quite simple to inspect.

The boat is pretty much the original 12 VDC  setup, except for the new engine and new electronics and 12 VDC refrigerators. The AC wiring is only used while on the dock and there is no generator on board.

Any comments or advice taking into consideration this is not a Super Maramu?

Alex

SIMPATICO

Maramu hull #94, 1981