Eric and Bill,
Thank you for your speedy comments and warnings. I will share your input with my electrician tomorrow and get back to you.
Jim SM #207
On 2016-04-25 21:46, sailormon firstname.lastname@example.org [amelyachtowners] wrote:
AS BILL MENTIONED THE GENERATOR/ENGINE START BATTERY NEGATIVE SHOULD
NOT BE CONNECTED TO THE HOUSE BANK.
THE GENERATOR HAS A FLOATING GROUND WHICH MEANS AS SOON AS THE
GENERATOR IS STARTED THE GENERATOR IS DISCONNECTED FROM THE BATTERY,
THE ONLY THING THAT IS CONNECTED TO THE BATTERY WHEN THE GENERATOR IS
RUNNING IS THE ISOLATED GROUND ALTERNATOR.
DID YOU CHECK TO SEE WHERE THE LEADS FOR THE BLUE SEAS VOLT METER ARE
IF IT HAS ITS GROUND HOOKED TO THE GENERATOR YOU WILL GET AN ERRONEOUS
READING AS IT IS NO LONGER CONNECTED TO THE BATTERY. WHAT READING DO
YOU GET WHEN THE ENGINE IS RUNNING?
MAKE SURE THAT THE VOLTMETER IS CONNECTED BOTH NEGATIVE AND POSITIVE
DIRECTLY TO THE BATTERY.
I BELIEVE THIS MIGHT BE YOUR PROBLEM.
KIMBERLITE AMEL SUPER MARAMU #376
SENT: Monday, April 25, 2016 8:51 PM
SUBJECT: Re: [Amel Yacht Owners] Onan Generator and Starting Battery
I think the only person(s) capable of answering your start battery
question is the previous owner and/or the person that installed that
Bluesea battery monitor because Amel did not. Assuming that it is
installed correctly (it sounds like that could require a leap of
faith), you probably have a short in the 12vdc alternator on the
generator... But that is a wild guess.
And, the starting battery is 12vdc and the house battery system is
24vdc. They should be isolated from each other.
Have you located the shunt on the negative side of the starting
battery? Where is it? Take a photo? I think you probably have an
installation problem with your monitor.
BeBe Amel 53 #387
Sent from my tablet
+1832-380-4970 USA Voice Mail
On Apr 25, 2016 7:12 PM, "email@example.com [amelyachtowners]"
I have a question regarding my 6.5 KW Onan Generator and the voltage
reading of my starting battery when the Generator is running. When my
generator is off and not running the starting battery voltage reading
my Bluesea system monitor reads 12.8 volts but when I turn the
on the voltage reading is only 3.5 volts. Also it appears that when I
turn the glow plugs on prior to starting the generator the grounding
relay is activated and once the generator is started the grounding
turns off. Does anyone have an idea why my Bluesea monitor is reading
low starting battery voltage when the generator is running and how to
Also should the starting battery negative terminal be connected to the
negative terminal of the house batteries? I do not see a link between
the two at this time.
Thank you for your help in advance.
Jim, S/V Liebling SM #207
Puerto Vallarta, Mexico