On May 30, 2016, at 23:48, Andrew Lamb andrew.lamb@... [amelyachtowners] <amelyachtowners@...> wrote:

Yes I am not sure how else one would connect them, perhaps with a copper tie rather than S/S certainly one of the wires looked very corroded.

Andrew

SM 472

On 31 May 2016, at 05:28, 'sailormon' kimberlite@... [amelyachtowners] <amelyachtowners@...> wrote:

 

Amel connected almost of the bonding on Kimberlite with S/S hose clamps.

Haven’t had a problem in 14 years.

Fair Winds

Eric

Kimberlite Amel Super Maramu #376

 

 

From: amelyachtowners@... [mailto:amelyachtowners@...] 
Sent: Monday, May 30, 2016 11:25 PM
To: amelyachtowners@...
Subject: Re: [Amel Yacht Owners] Kent !!!

 

  

If you check that there is no continuity between the AC grounding (green/yellow) and the charger case AND there is no continuity between DC -ve and the charger case then it may be OK to connect it to the boat bonding. I would agree that the safest bet is to not connect the charger case to anything. 

 

The article that Bill Kinsey provided a link to is very good. Interesting that it says "Do you have wires attached to sea cocks with hose clamps? Forget it. This is putting stainless and copper together, which are galvanically incompatible and it won't work" - I found Amel had done this on a cock I changed under the holding tank in the forward head at the weekend.

 

Andrew

SM 472

 

Canet en Roussillon

 

On 30 May 2016, at 23:11, 'Bill & Judy Rouse' yahoogroups@... [amelyachtowners] <amelyachtowners@...> wrote:

  

Good advice, Kent.

Bill Rouse
BeBe Amel 53 #387
Sent from my tablet
+1832-380-4970 USA Voice Mail

On May 30, 2016 5:09 PM, "Kent Robertson karkauai@... [amelyachtowners]" <amelyachtowners@...> wrote:

  

Enio,

I would not connect anything to the "grounding" screw for now.  It should work fine.  If you think there might be a problem with the charger before you can find a qualified electrician, check with your multimeter for voltage between the case and the engine block before you touch anything that might give you a shock...or better yet, just charge with your engine until you find the right electrician.

 

My charger is NOT grounded to anything now.

 

I'm not an expert by any means, so please feel free to critique my advice, anyone.

Kent

SM 243

Kristy

"Currently" Bonaire

On May 30, 2016, at 3:07 PM, rossienio@... [amelyachtowners] <amelyachtowners@...> wrote:

  

Thanks friends for all details. But I'm not able to find a qualified electrician able to know the electrical system of an Amel boat, nor are able to figure it out myself. But I need to know if I have to connect somewhere the Sterling heart or not. Can someone tell me somethings in addiction to formal notice of Kent (thank you Kent) connect the host to the bonding system?  Thanks  Enio