When it rains it pours...
The tank on my SN#68 just sprung a leak. I haven't taken it out yet, but It appears a straight-forward job to remove and carry out to the cockpit. (not being in the engine room as the 54 must be).
I'm guessing it's the same 5086 H111 AL, Joel, that you noted for the Amel 54. Yes?
Also, does anyone have a schematic of the tank?
I'm up in Vero Beach, FL and had Tank-Nicians recommended for fabricating a replacement - anyone have any experience with them or can recommend others?
Will appreciate any suggestions.
Cheers, Craig Briggs SN#68 Sangaris
, wrote :
Hi Bob. I
t is considered bad form to kill the messenger bringing bad news. The tank in your boat cannot be removed without cutting it in pieces. It is made from 5086 H111 aluminum alloy. Two tanks will need to be fabricated to fit in the same space. I have confirmed this with Olivier. Sorry to have this news to give you. If you send me your email address, I can send you some free advice that will be worth much more than it costs.
Before you Amel folks with an Amel 54 panic, there are extenuating circumstances which most probably led to the failure of the tank on this particular boat.
Joel F. Potter/Cruising Yacht Specialist LLC
THE EXPERIENCED AMEL GUY
954 462 5869 office
954 812 2485 cell