The generator has my attention...again.
This morning it shut down with a "3" fault code, which the manual said requires service by trained personell. I then read there is a second level code accessed by pressing the STOP once. I got the "58" fault code, "High Exhaust Temperature".
-Impeller: it's all there, no apparent damage. Although strangely one of the vanes was bent the wrong way at the "pump side".
-Coolant or raw water leaks: none apparent.
-Coolant level: unchanged in the surge tank.
-Temperature of the water in the muffler: it was surprisingly at room temperature???
-Seachest for blockage: it was clear.
-Exhaust elbow: not particularly hot (water didn't sizzle).
I tried to let it cool down and restart it so that I could get a temperature on the exhaust elbow. It would start, but would not run for more than a few seconds, and then flashed the same fault code.
About eight months ago I had a "High Engine Temperature" and found that the exhaust elbow waterjacket had a hole in it, and the heat exchanger would not hold pressure. I replaced them both and haven't had a problem with high temp's again until now.
I did check that water was being ejected in the exhaust immediately after starting and it was normal. I'm perplexed, what could be the problem?
Could this be a result of the freshwater leak into the generator from the watermaker flush valve?