Re: [Amel Yacht Owners] No Stop, then No Start on Yanmar 4JH3-HTE

Eric Freedman

You might apply 12 volts to the stop solenoid, You might hear it click.  You must disconnect it completely from any wiring. you will need to pick up the heavy negative from  the valeo solenoid and the positive off of the big cable on the starter motor. Doing this a few times might unstick the solenoid if that is the problem.

Fair Winds


Kimberlite Amel Super Maramu #376



From: amelyachtowners@... [mailto:amelyachtowners@...]
Sent: Saturday, June 17, 2017 11:28 AM
To: amelyachtowners@...
Subject: [Amel Yacht Owners] No Stop, then No Start on Yanmar 4JH3-HTE



Am I posting too many problems?  Man, it seems like it to me!


After 38 hours of motoring we dropped anchor, let the engine cool down for 10 minutes, then hit the stop button.  The engine didn't stop right away.  I had to hold the stop button down for maybe 10 to 15 seconds to stop it.  That had never happened before.  During that time the engine sounded unusual, like some cylinders were not firing.


Then the next morning the engine would not start.  The starter ran fine, and the engine turned over but would not fire.  I started checking assuming a fuel problem.  I switched the dual Racor over to the other filter, still no start.  I checked the main fuel filter bleed screw to see if there was fuel in the filter and there was plenty.  I then pulled one of the injector pipes off the injector and turned the engine over, no fuel.  I then replaced the engine main fuel filter, still no start.  It seems fuel is not getting to the cylinders, but there is no obstruction in the fuel path, as evidenced by the ease of purging air from the fuel filter.


It seems to me that it must be the stop solenoid (I assume that's what the stop button actuates), but I'm not sure where that is on the engine (not much of a mechanic am I?).  The fuel pump appears to be engine driven, not electrical.  I will post a few photos of that side of the engine in the folder "Wanderer".

If it had something to do with the "stop solenoid" my understanding is that the fuel is always on unless the stop solenoid interrupts the flow.  It could be failing based on the difficulty in stopping the engine, but why now will it not start?  Did it fail in the "fuel off" position?

The starter operates normally.


MY OTHER PROBLEM:  I've cranked the engine enough that I'm worried the water lift muffler might be full.  The muffler is between the engine and the fuel tank.  The drain is toward the stern and I can't get my hand/arm down there to remove the cap (the exhaust hose takes up most of the space).  It looks like I'll have to remove the exhaust hose to get to it.  Has anyone found a clever way to do this?  It looks like the easiest way would be to remove the exhaust elbow and run a small diameter hose down the exhaust hose to the muffler and pump from there.


We had TowboatUS bring us in the last few miles to the marina, if not for the insurance it would have been a $780 tow!  Worse than that we would have been in the Bahamas just a few days ago!


Thanks in advance for any help.


Wanderer, SM#477

Currently in Brunswick, GA

Join to automatically receive all group messages.