Re: [Amel Yacht Owners] Replacement Generator exhaust hose (install) [2 Attachments]
Terry,
I always operate under the assumption that if it was done a certain way on an Amel there is probably good reason for it. Although, sometimes the reasons aren’t obvious, at first.
With best regards,
Mark
Skipper Sailing Vessel - Cream Puff - SM2K - #275 Currently cruising – St Kitts - Nevis www.creampuff.us
From: amelyachtowners@...
[mailto:amelyachtowners@...]
Sent: Friday, June 30, 2017 2:01 PM To: amelyachtowners@... Subject: [Amel Yacht Owners] Replacement Generator exhaust hose (install) [2 Attachments]
[Attachment(s) from singh_terence@... [amelyachtowners] included below] During Libby's haul out this week, we bit the bullet and decided to change out the Generator exhaust hose and Vetus Waterlock. Good decision as the original hose was in very bad condition.
The yard did a good job, how ever I have one question that I need help with.
The factory installation of the exhaust hose had it loop upwards out the the Waterlock to the underside of the cockpit floor.
The new installation has the hose looping up to within 6 inches of the underside of the cockpit floor.
The anti syphon break is still in its original original position.
My question.
Is the 6 inch difference in the loop height critical especially if the boat is heeled over hard.
Pictures of the difference in installation height are attached.
Any clarity would be appreciated.
Terry.
|
|