Re: Charging / Discharging issue
Agree with Ryan and Kent, something is not right. I have six 110Ah AGMs and run the galley frig, one salon freezer, a 24v portable chest cooler, VHF, anchor light, and a 230v inverter supplying an icemaker, and two laptops and phone chargers. There is an occasional load from the microwave.toggle quoted messageShow quoted text
We have 630 W solar which carries the constant load, and charges batteries at ~5 amps during a sunny day. In the evening the battery will discharge at a rate between 2 and 10 amps depending on what is cycling on. Average night we will draw down the battery ~24%.
My routine is to run the genset once in the morning and bring the batteries to ~95% then let the solar complete the charge during the day. The charge starts out putting in ~95A and tapers down as the battery voltage comes up. Charge time is usually an hour or less.
Like you we run 100 amps of charging via one 60A and one 40A charger which work together until voltage reaches 28 volts. Our finishing voltage is 28.5V. The chargers float the battery at 26.5V, the solar floats at 27.5V We have a battery monitor on the DC breaker panel in the galley that monitors charge rate, Ah in/out, voltage and % capacity.
The % capacity is a "calculated data point." It uses some information that you have to program in including the size of the battery bank. If the size is incorrect it will affect how it calculates capacity.
I don't think your genset would affect the charge rate or battery issues, so you can at least not worry about that part of the system.
A photo of your battery monitor and maybe take some readings of voltage, current and %capacity every 15 minutes during your next charge would help figure out what is going on.
SV Annie, SM 37
Druif Bay, Water Island USVI
---In amelyachtowners@..., <ryan.d.meador@...> wrote :
How were you measuring the battery capacity? Are you using a built-in battery monitor? I wonder if there could be something wrong with that. What did it show for the charge current when you were running the 100A charger? What about the charge current when the solar and wind were going? What was the current draw from your electronics?
Are you sure all of the batteries are connected? Check the connections, and also check any battery terminal fuses that may be installed.
It would be worth a sanity check with a multimeter to verify the voltage at the battery bank is what the monitor claims (and you can also use this voltage with some tables you'll find online to estimate the state of charge, if there is no load/charger on the bank when you took the measurement). You can also use your multimeter to measure the voltage across the shunt resistor used by the battery monitor; with the shunt's resistance (should be printed on it) and Ohm's law you can verify the current flow.
SM 233 Iteration
Boston, MA, USA