Re: [Amel Yacht Owners] Easy and novel way to remove membrane end caps.


ianjenkins1946 <ianjudyjenkins@hotmail.com>
 

Bill,


 I think you've mixed us up--mine is the solution with the beer; Eric's is strictly teetotal ( I know, it's hard to believe he's a real sailor!)


 Ian


From: amelyachtowners@... on behalf of Bill Rouse brouse@... [amelyachtowners]
Sent: 23 August 2018 14:41:39
To: amelyachtowners@...
Subject: Re: [Amel Yacht Owners] Easy and novel way to remove membrane end caps.
 


Ian, 

You could improve on your method by adding one of Eric's steps...the beer.

Best,

CW Bill Rouse
Admiral, Texas Navy
Commander Emeritus

Amel School  http://www.amelschool.com
720 Winnie St
Galveston Island, TX 77550

+1(832) 380-4970

Any opinions and conclusions expressed in this message are solely those of the author and should not be construed as representing the opinion of an expert. Manufacturers' and Expert's precautions must be considered when dealing with mechanical and/or electrical systems to ensure that you are NOT harmed, and/or the device and/or system is NOT ruined. If in doubt, do not touch any mechanical and/or electrical device or system referred to above.


On Thu, Aug 23, 2018 at 6:47 AM Ian & Judy ianjudyjenkins@hotmail..com [amelyachtowners] <amelyachtowners@...> wrote:
 

Alternatively.....take a short piece of webbing and make a loop, trapping the ends of the loop onto the end cap with a jubilee clip.  Sit down in the cockpit with a beer. Put the loop over a cleat on the mizzen mast and give the tube a sharp tug.  Bingo! (  only two hands needed and you don't get wet ! )


Ian and Judy, Pen Azen, SM 302 Greece


From: amelyachtowners@... <amelyachtowners@...> on behalf of michael winand mfw642000@... [amelyachtowners] <amelyachtowners@...>
Sent: 23 August 2018 06:21:08
To: amelyachtowners@...
Subject: Re: [Amel Yacht Owners] Easy and novel way to remove membrane end caps.
 


Nice method 
Michael 


On Thu, 23 Aug 2018 at 12:46, eric kimberlite@... [amelyachtowners]
 


Once you have the membrane assembly apart disconnect the membranes from each other. Put a 1/2 inch tubing over the hose nipple with a hose clamp. This is connected to a water supply, dock or boat water, turn on the water. Let the air escape and then put your finger over the hole where the water is escaping. 

Hold the hole closed with your finger. As the water pressurizes the vessel  the end caps will slide out due to water pressure . Just hold the loosest end cap  in place until the second one comes out.
Easiest way yet to remove the end caps. 3 hands is helpful.

Oh don't forget new O rings.
Fair Winds,
Eric
Sm 376 Kimberlite

On Wed, Aug 22, 2018 at 05:33 PM, Danny and Yvonne SIMMS simms@... 




Join main@AmelYachtOwners.groups.io to automatically receive all group messages.