Based on the very
bad advice of Coastal Climate Control in the USA, I installed the March AC5-C-MD
as a replacement to the original Calpeda pump. The first pump they sold me was
defective and I had a difficult time getting them to replace it. The second
pump has worked fine and is working satisfactory after 3 years. It was easy to
install as it has basically the same footprint. At first, I was happy with the performance
of the pump. However, the outer parts of the pump are starting to rust,
especially the capacitor housing. I fully expect the pump to have a life
expectancy much shorter than I had hoped. It is certainly not a perfect
replacement for Calpeda and doesn’t fair well in the Amel engine room. I fully
expect to have to replace the pump again during our ownership of Cream Puff..
I have notice
on the newer model March AC5-C-MD pumps, the capacitor housing is now encased
in what appears to be plastic. Since this is the area rusting the fastest, it
is a big improvement on the design of the pump.
- Cream Puff - SM2K - #275
cruising - Santa Marta, Colombia
Here is an example of a March liquid cooled
I had the pump in my hands in St Maarten.
It is totally encapsulated in what appears to be some form of epoxy and
NOT PAINT and there is no way for it to rust.
There are 2 copper pipes coming from the
pump section to cool the motor. I would however get the next size larger to get
maximum water volume.
Kimberlite Amel Super Maramu #376
I believe this is the wat to go.
was curious and looked at the March info. I believe the 'AC' designation
refers to an open style motor that should not be exposed to the possibility of
water getting on the motor. The 'CP' designator is an open drip proof motor
that would tolerate exposure to some drippage (?) from above. They also
have TEFC motors available for some direct exposure to water. However, I
think all these motors except the 'LC' submersible variety are standard carbon
steel motor housings with some form of a painted finish that apparently does
not tolerate a salt air or humid environment i.e. they all will show surface
rust at some time. Good luck with your preventative maintenance project.