Re: Prop shaft bearing
toggle quoted messageShow quoted text
On the Sharki, you must undo the motor mounts and lift the engine up about 20"/inches 50 cm in order to remove the propeller shaft as it is too long to fit as it hits the rudder skeg. It is an easy 6 hour job if nothing is badly rusted.
To remove the prop shaft/cutless bearing, remove the propeller, un-tighten the bolt holding the bearing in place on the side of the stern tube and use a pipe wrench or a chain wrench to rotate the cutless out. Easy one hour job.
All The Best, Joel
JOEL F. POTTER-CRUISING YACHT SPECIALIST~L.L.C.
THE EXPERIENCED AMEL GUY
UNSURPASSED AMEL MARKETING EXPERIENCE AND PRODUCT KNOWLEDGE
Office 954-462-5869 Cell 954-812-2485
Hello Captains of Amels,
I have to change the cutless bearing of my Sharki, because of vibrations under engine wich occurred after I was installing a shaft alternator...
How do I pull the propshaft?
Do I really have to lift the engine?
Any suggestions of a Sharki, Maramu or Mango owner would be greatly appreciated....
Former owner of SM#69 “Yin Yang”,now owner of Sharki#83 “Rock’n Roll”,currently in Teneriffe...
It feels good to back in this great forum