Re: Furling motor brushes

david bruce
 

Thanks Danny,   
Going to order a few of the Eurton brushes and plan to modify if or more accurately when they are needed.  
Appreciate the advice.  

Best, Dave
Liesse  SN 006 


On May 29, 2019, at 12:30 PM, Danny and Yvonne SIMMS <simms@...> wrote:

Hi again Dave, Just a little more on this. Put the file on a flat surface and rub the brush back and forth on it. Much more controllable that way.

Regards

Danny

SM 299

Ocean Pearl

On 30 May 2019 at 07:22 Danny and Yvonne SIMMS <simms@...> wrote:

Hi Dave,

If you need to reduce the size of carbon brushes it is easily and accurately achieved with a file.

Regards

Danny

SM 299

Ocean Pearl

On 30 May 2019 at 06:31 CW Bill Rouse <brouse@...> wrote:

Dave and Shelley,

There are at least 5-6 different Mainmast furling and outhaul motors tat have been used by Amel over the years. Additionally there are 12 volt (like yours) and 24 volt.

I suspect that even SAV at Amel cannot answer your question, except to say, "NO, the brushes are not the same."

I saw the slightly smaller brush used successfully by SM233 Iteration. Normally I would record the source of that brush as one to refer to my clients. I did not because I believe at some point that smaller width brush will cause a problem when it wears and the length becomes shorter. I may be wrong, and I am sure that only multiple experiences over time will prove me right or wrong.

One thing for sure is that you can always buy a larger electric motor brush and cut it to size. This is the safe solution. You may have to take the larger brush to a machine shop to have it cut.

Best,

Bill Rouse
720 Winnie St.
Galveston, Texas 77550
832-380-4970



On Wed, May 29, 2019 at 1:20 PM < davidcbruce57@...> wrote:
Thanks for this sourcing information Kelly and Ryan.  

 Would anyone (Bill?) know if the brushes on all furling motors on a given boat as well as those on different model boats such as SM and SN are the same?    

Thanks, 

Dave and Shelley Bruce
Liesse, SN006 
Gaeta, Italy 

On May 28, 2019, at 3:48 PM, Kelly Ran < naryllek@...> wrote:

Hi all,

We recently needed to change the brushes on our main furling motor (Leroy Somer MBT86M).

I found an 8mm x 10mm x 17mm brush which works for us, so far. Unsure of the material but it looks similar to electrographite.

It seems that other owners have issues sourcing this brush, so here is the info:
Eurton Electric  SPR-A007  
7.50USD, ships from California

We also found that Maude has some slightly different brushes (8mm x 9mm x 16mm) in stock right now for 24 Euros. We did not order these, as the Eurton brushes work.

Fair winds,
kelly + ryan
SM233 Iteration
Boston

 

 


 


 

Join main@AmelYachtOwners.groups.io to automatically receive all group messages.