toggle quoted messageShow quoted text
If you provide a path, water will flow to the lowest part of the bilge. This does not have to be a limber hole though that is the fastest form of transport. ,You can use something absorbent to form a wick that siphons the water slowly from the pool up higher to the lower bilge. Fill a bucket half full and stick part of the towel into the bucket and lay the rest of the floor...
On Jun 9, 2019, at 12:19 AM, karkauai via Groups.Io <karkauai@...
Well, that makes sense...duh? lol
I guess that’s why they pay you the big bucks, eh?
USA cell: 828-234-6819
On Jun 8, 2019, at 9:45 PM, Danny and Yvonne SIMMS <simms@...
try healing on the opposite tack and bringing the water back to the middle. Lay some sponges there to catch it before it disappears to the other side
On 09 June 2019 at 10:32 "karkauai via Groups.Io" <karkauai@...> wrote:
Thanks Danny. I’ve tried that and if I twist into a pretzel and stand on my head I can get most of it on the starboard side, but not even close on the port side.
USA cell: 828-234-6819
On Jun 8, 2019, at 3:50 PM, Danny and Yvonne SIMMS < simms@...
I have a paddle wheel speed transducer that I swap for a blank when I leave the boat on the mooring to avoid it getting clogged up with marine growth. The swap always results in a few litres of water. I have a large sponge I use to mop it up and transfer it to the shower drain. A long arm on that sponge might reach behind the stringer, or if the arm is too short, extend it by tying the sponge to a stick.
On 09 June 2019 at 05:14 "karkauai via Groups.Io" < karkauai@...> wrote:
If it’s leaking when we set out, I fix it. If it starts leaking while on passage, (and it has done this twice in 10 years), I’ve just kept an eye on it until I get to port. Both times it wasn’t a lot of water, but enough that I pumped it into the shower when it got to be a few liters.. that was still enough to get some outboard of the stringers when close-hauled. Once in port I do the seal changes.
If anyone has ideas about how to remove the water that gets outboard of the stringers, I’m all ears.
On Jun 8, 2019, at 10:00 AM, karkauai via Groups.Io < karkauai@...
Thanks Mark. I guess they drilled through the shower pan into the space below? I have an alarm but have to pump by hand or with a 24v hand-held Pump. So far the worst it’s been was 3-4 liters that collect in a couple of places that I can get to. Some water collects outboard of the stringers if we’re heeled over, and there’s no way to get it out. I’d like to collect it in the forward cabin just aft of the bow thruster and pipe it directly into the drainage system that drains the forward AC condensate.
Has anyone tried that?
On Jun 7, 2019, at 8:52 PM, Mark Erdos < mcerdos@...
I think Cream Puff was retrofitted. We have a pump in the area that collects water from the leaking bow-thruster area connected to a sensor and alarm. When the sensor kicks in the alarm sounds and the pump automatically pumps the water into the forward head shower pan that obviously makes its way to the bilge. The alarm can be silenced for those trips when the bow thruster seriously need new seals.
I particularly like this set up because no modification was made to the watertight bulkhead.
With best regards,
Sailing Vessel - Cream Puff - SM2K - #275
Currently cruising - Vista Mar, Panama
Can that change be retrofitted to a 1999 SM?
On Jun 7, 2019, at 8:11 AM, CW Bill Rouse <brouse@...> wrote:
Late model SM Bow Thrusters do capture any sea water seepage and drain that to the gray water bilge. This change was done sometime in 2003.
CW Bill Rouse
Yacht School - Supporting Amel Owners
720 Winnie St
Galveston Island, TX 77550
On Thu, Jun 6, 2019, 6:40 PM Gary Wells <gary@...> wrote:
My bow thruster will not leak to an exit to the bilge. It will be stopped at the forward head where it must be dealt with manually. If you have a situation where seawater has a direct path to the the engine room bilge (other than the anchor locker), I would say that it's not original (or I didn't read your statement correctly). ..
Having a water alarm next to the rudder quadrant is a great idea. I just have to hoist the bed once a month while we're parked, once a day while we are underway.
SM 209, Adagio