1. Messages
  2. [Amel Yacht Owners] Bow locker seals

Re: [Amel Yacht Owners] Bow locker seals

CW Bill Rouse
 

Kent,

If I am not mistaken, they have exactly what I think will work best, which is CACD240:
image.png

 

 


A

B

C

D

E

R

Figure
Letter
(See Above)

CATALOG
NUMBER

Base Width

Wall

Open Height

Base T

Total Height

Radius

B

CACD240

1"

1/8"

9/16"

5/16"

1"

-

 

Let me know what they say

Best,

CW Bill Rouse
720 Winnie St
Galveston Island, TX 77550
+1(832) 380-4970



On Sun, Aug 4, 2019 at 3:11 AM karkauai via Groups.Io <karkauai=yahoo.com@groups.io> wrote:
Here’s the site I was looking at.  These are truly half-round with base 1”, height 1/2”(not 1”).


I’ll contact them and Steve’s site to see if I can find 1” x 1” high D profile in neoprene.

Kent Robertson
S/V Kristy
USA cell: 828-234-6819

On Aug 3, 2019, at 10:42, CW Bill Rouse <brouse@...> wrote:

Steve, 

Note that Trim-LOC says it uses EPDM Rubber. 

EPDM is related to polyethylene...I assume that this will be similar to polyfoam. The specs state that "compression Rating Recommended 25% compression for the maximum performance." This is where I had a failure with the gasket I previously used. If you notice the weight of the engine room hatch, it will compress the D Gasket to more than 25%, especially if the center hole is large.

Maybe the one that Kent found with a 3/16" hole will be the best.


It will take about 90' to do everything.

Best,

CW Bill Rouse
720 Winnie St
Galveston Island, TX 77550
+1(832) 380-4970



On Sat, Aug 3, 2019 at 1:34 PM Stephen Davis <flyboyscd@...> wrote:
Hi Bill,

How does this product look using the BT Tape?  


Regards,
Steve
Aloha SM72
Join main@AmelYachtOwners.groups.io to automatically receive all group messages.