Hi Mohammad,

Hi Nick;

 

Amel has already worked out the pin size issues you are addressing. We had the same concerns, but after talking to ACMO, found out they have simply gone to a stronger material for the pins and kept the pin sizes the same as existing. You will receive everything required to make the change from ACMO. No changes to the boat are required in any way.

 

We just replaced all shrouds at the main with zero issues.

 

Happy Sailing;

 

 

Mohammad and Aty

B&B Kokomo

AMEL 54 #099

 

From: main@AmelYachtOwners.groups.io <main@AmelYachtOwners.groups.io> On Behalf Of CW Bill Rouse via Groups.Io
Sent: Thursday, October 10, 2019 8:09 AM
To: main@amelyachtowners.groups.io
Subject: Re: [AmelYachtOwners] Standing rigging on 54

 

Nick,

 

ACMO will ship you what you need...they know what you need and have been doing this for a while. 

 

Regarding your question about substitutes of wire, etc., That needs to be answered by the 54's designer, Amel. I am sure their advice is to use the ACMO solution, since they worked out this solution with ACMO.

 

Hopefully, you are aware that the two intermediate shrouds also changed since the 54s introduction to 10mm, rather than 8mm.

--

	CW Bill Rouse Amel Yacht Owners School +1 832-380-4970 | brouse@... Address: 720 Winnie, Galveston Island, Texas 77550  Website: www.AmelYachtOwnersSchool.com

 

 

 

On Thu, Jun 6, 2019 at 11:26 PM ngtnewington Newington via Groups.Io <ngtnewington=aol.com@groups.io> wrote:

Further to the news that the Amel 54 should have 12mm aft lowers not 10mm and that the intermediates should be beefed up from 8mm to 10mm. I am now seriously working this out.
On the face of it I can order the replacement wire and fittings from ACMO in France and have it a week later. What worries me is that the pin sizes will increase (I guess)
This should be no problem at the bottom where there is a massive chainplate that I could drill out to accept the bigger pins but at the top at the spreader bases it will be tricky.
Has anyone been there and done this project?
What about sticking to 8mm and 10 mm but upgrading the wire quality to say Dyform? Dyform offers about 30% more strength than standard 1x19?
Any experts out there?
Nick
S/Y Amelia AML54-019
Anchored in Kefalonia enjoying easy living after 2000 mile voyage from Canary Islands.