Companion way for removal
toggle quoted messageShow quoted text
I wanted to replace the veneer on Kimberlites companionway and replace it with laminate.
To get to the entire door off you have to remove the hard dodger.—NO WAY--
I removed the stop and blocked the companionway door all the way up till it touched the dodger. I then made a rail the height of the side trim.
Using these rails and a router I was able to get to the edges of the door. Of course the veneer that is under the trim cannot be replaced but it cannot be seen. I then routed the entire door and applied the laminate- I used Formica brand color teak. Seven years and it is still holding up. However it is important to use wax to block the UV on the Formica.
Kimberlite Amel Super Maramu #376
From: main@AmelYachtOwners.groups.io [mailto:main@AmelYachtOwners.groups.io] On Behalf Of Scott SV Tengah
Sent: Saturday, October 12, 2019 1:07 PM
Subject: Re: [AmelYachtOwners] Companion way for removal
I just did this job. Assuming the Maramu is similar to the A54, you just need to remove the small rectangular sheet of plywood that keeps the door from going too low. With it removed, you can drop the door far enough to replace the weather seal. I went nuts and removed the companionway steps - this is unnecessary unless you want to clean behind them while you're at it!
If you close the door from the inside and look near the bottom of the door, there should be screws and bolts securing a rectangular piece of plywood, which itself is behind/aft of the companionway door. On ours, it's held by 3 wood screws and 2 bolts. Careful with the bolts as they have tiny nuts which you may lose as you're removing them.
We just sanded the veneer with the door in-situ. If you want to remove the door completely, I think you need to remove the hard dodger. Hope this helps.
2007 A54 #69
Join main@AmelYachtOwners.groups.io to automatically receive all group messages.