Hello folks

I’m just in the process of replacing the keel bolt bonding strap on my 1985 Maramu.

It’s led to some head scratching re bonding and grounding and the wiring runs on these lovely boats.

SeaLove has a copper ground plate on the skeg. I assume my radar is grounded to this. Perhaps also my furuno weatherfax etc

Can anyone be kind enough to explain where the connection to the ground plate typically surfaces?

Also to check my assumptions re the bonding system setup. . . .
I think  all bonding cables run onto a connection in the transom as per the photo attached



It ‘looks’ like this copper plate is glasses into the hull and runs down the transom to surface near the rudder via the two tubes shown on the left in the photo below :


For some reason this surfaces as 2 separate cables that then are both connected to the rudder stock, and hence the anode on the rudder :




Does  this bonding setup look about right ?

Slightly confused as to why there are 2 cables here ?


Many thanks in advance

Miles
Maramu 162