- Iridium go external antenna location
Re: Iridium go external antenna location
toggle quoted messageShow quoted text
Courtney, here are some more photos of the engine bracket. I have seen it on other Amels. The wood is a real Marine laminate. There are two SS straps that giver the top rail and hold it all together, as well as the engine clamps. It straddles one of the verticle supports for the rail. And is positioned for easy lifting with the mizzen ballooner halyard or a line thru a block at the mizzen spreader.
Let me know if you have additional questions.
On Wed, Mar 4, 2020, 2:01 PM Courtney Gorman via Groups.Io <Itsfun1firstname.lastname@example.org
Hi Dan would you mind sending me a picture of your outboard I like the way it is secured also did you add any reinforcement to the board it is attached to?
From: Dan Carlson <carlsdan61@...
To: main <email@example.com
Sent: Wed, Mar 4, 2020 12:30 pm
Subject: Re: [AmelYachtOwners] Iridium go external antenna location
Hi Scott, here is a picture of my antenna mount, the wire pass thru the deck with compression fitting, and the inside mount by the nav station. I used an existing hole in edge of the deck. I also installed the same compression fitting in the hole through the bulkhead into the rear cabin. This allows the slightly oversized hole for the cable to pass. It took most of the cable length I had (probably the same as you) to reach the nav stations.
We are not are of any issues with the signal. Used it half of last season and the last few months if this season across the Caribbean from Panama to the DR.
We never touch the Iridium unit itself except to turn it off once in a while. We have a 5 USB port charging block there for keeping all of our other devices charged up as well.
It was not that difficult on an SM. Just a few tight turns around the aft hanging locker.
Best regards, Daniel Carlson on sv BeBe, SM#387
We just scored a great deal on a used Iridium Go with the external antenna. It comes with 12m of antenna cable and the mount for steel tubes.
Any suggestions on where to mount the external antenna? I'd like to mine your collective knowledge before I start drilling any new holes. We have a large aft solar arch and assume putting it back there would degrade the signal.
Additionally, how have you all run the thick antenna cable into the boat? I would like to put the Iridium Go at the nav station, but that's not a requirement.
Thanks in advance!
2007 A54 #69
Join main@AmelYachtOwners.groups.io to automatically receive all group messages.