- Onan ballbearing check and valves values
Re: Onan ballbearing check and valves values
Oliver Henrichsen, SV Vela Nautica
toggle quoted messageShow quoted text
Hello and thanks 4 your answers.
But the question was:
Is there a procedure to check the generator bearings for wear? As mentioned in the manual / service plan?
Oliver from Vela Nautica Amel54#39
On Sun, May 17, 2020, 18:41 CW Bill Rouse <brouse@...
Sorry, guys. I did exactly the same thing as Gary Silver, and the bearing was never installed.
On Sat, May 16, 2020 at 12:45 PM Craig & Katherine Briggs SN 68 Sangaris Tropic Isle Harbor, FL via groups.io
It's been awhile, but I replaced the rotor bearing on my Northern Lights 6kw genset in situ with little difficulty. The rotor remains bolted to the flywheel as you remove the end with the bearing - no external support needed. I recall I did the old put-it-in-the-freezer trick to shrink the bearing and it slid in with no press needed. That was at about 3000 hours; now I'm at 7500 and am overdue, so will tackle again soon. (I'm getting a very slight vibration with heavy loads.)
If you want to remove the rotor, as I did because it needed rewinding from salt water corrosion shorting the wires ($176 in La Paz VZ), it's heavy but quite manageable by hand. However it doesn't sound like you'd need to remove it for the 2500 hr. (if I recall correctly) bearing replacement..
Join main@AmelYachtOwners.groups.io to automatically receive all group messages.