Re: New Thread on A54 fridge pumps (ATTN: OLIVER Vela Nautica)



I wish I was on your 54 with you because I have a burning question about all of this. and I have a recommendation for you.

My burning question:
If you see the schematic in my previous post in this thread, you will notice the schematic from a Frigoboat manual. The source of the voltage output from the E51385 blue box to the water pump originates in this schematic with each of the Danfoss Compressor Controllers at the F terminal. In fact, the two wires for each fridge unit come directly from the Danfoss to the E51385. The Frigoboat manual clearly states, regardless of the voltage of the fridge the output on the two F terminals is 12 volts. BTW, the Danfoss operates on 12 or 24 volts, but always outputs 12 volts to Terminal F. Have you checked the output voltage on each of the Danfoss on terminal F and the terminal next to it? I do not see any other way that the E51385 blue box can output 24 volts and if there is 24 volts on the Danfoss fan terminals, I suspect something is wrong with the Danfoss.

My recommendation:
Why don't you do this eliminating the E51385 and eliminate the limitation on amps on the Danfoss terminal F, and run a 24-volt pump??:
Relays to control water pump.jpg
CW Bill Rouse Amel Owners Yacht School
Address: 720 Winnie, Galveston Island, Texas 77550 
View My Training Calendar

On Fri, Jul 3, 2020 at 2:02 PM Jamie Wendell <mysticshadow54@...> wrote:
OK, my "final" update on the Flojet pump and Frigoboat E51385  interface. I cannot explain it, but the interface is definitely out-putting 24 volts to the pump at all times.
Maybe my interface is malfunctioning, so I installed a solid-state relay and a DC converter to step the voltage down to 12 volts. I used a 24-volt relay in place of the E
51385 pump connection and then feed the converter and pump via the live 24-volt terminal box in the engine room. The relay simply engages the pump when the compressors call for it.

A bit more complicated than I would like but the pump runs perfectly now and obviously I no longer get the pump overload signals at the interface. The higher capacity pump may draw more power, but it really cools down the 3 refrigerator units fast.

My next task is to get the brushless motor working to replace the Flojet motor. I will drive it directly via the 24-volt terminal block and eliminate the DC converter.

Until then I am "over and out" regarding this perplexing issue with the E
51385. I really appreciate all the suggestions and assistance, but will report once I have the brushless motor controller operational. That will be the gold standard.

Phantom, A54 #44

Join to automatically receive all group messages.