Giovanni, we are arriving in Kilada on 11th, hope to launch on 17th and be afloat until 20th October, sailing at first in the Northern Cyclades and then wherever the wind takes us. Maybe our wakes will cross?

Ciao,

Ian

---

From: main@AmelYachtOwners.groups.io <main@AmelYachtOwners.groups.io> on behalf of Giovanni TESTA <giovannitesta53@...>
Sent: 04 September 2020 14:12
To: AMEL GROUP <main@amelyachtowners.groups.io>
Subject: Re: [AmelYachtOwners] Main Furling gear box connection to foil

 

...perfect Ian ! In the while Alban from Amel Marin told me the same. Where are you ? We are saling Greek waters.

Ciao

Giovanni

Il Ven 4 Set 2020, 17:01 ianjenkins1946 <ianjudyjenkins@...> <ianjudyjenkins@...> ha scritto:

Hi Giovanni , 

We took the sail off and disconnected the gearbox from the foil and then took the gearbox off the mast . 

This allowed the foil to drop down and the very bottom could then be gently pulled aft just enough to use a saw on it . 

Ian 

On 4 Sep 2020, at 14:27, Giovanni TESTA <giovannitesta53@...> wrote:



Dear Jan & Judy, 

Do you remember  their procedure to do that ? (Sail removed, lift down gear ecc ?)

After a saling around the world always with trade winds from port side, wrong side for furling, this is the consequence even if with big caution.

Many thanks  for your prompt support.

Giovanni

Il Ven 4 Set 2020, 14:04 ianjenkins1946 <ianjudyjenkins@...> <ianjudyjenkins@...> ha scritto:

Hi Giovanni,

 When we had the same problem after about 10 years and 50,000 miles the Amel team in Guadeloupe took about 2.5 cm off the bottom of the foil and drilled new holes. 

 One day I shall go up to the top of the mast when the main is up and see how many more times I can do that. If the length became really tight I'm sure there are other solutions, though none so easy.

 Ian and Judy, Pen Azen, SM 302, Kilada, Greece ( to where we fly  next week !)

---

From: main@AmelYachtOwners.groups.io <main@AmelYachtOwners.groups.io> on behalf of Giovanni TESTA <giovannitesta53@...>
Sent: 04 September 2020 09:07
To: main@AmelYachtOwners.groups.io <main@AmelYachtOwners.groups.io>
Subject: [AmelYachtOwners] Main Furling gear box connection to foil

 

Hi to all,
thanks to Duane Siegfri photos it was possible to see how the foil is connected to the furling gear shaft.
Well,  I suppose that my steel upper bolt has enlarged a little bit the relative hole foil as the 2 parts (foil+shaft) are no more perfectly tightened.
I m planning to cut some cm at botton foil for a new hole.
To do that I dont know how many cm ( anyway the minimum necessary ) I may cut to avoid problem on the foil top.
Before I have to go on the top and to see, any experience about? Any suggestions?
Many thanks in advance.
Giovanni Testa
sv EUTIKIA SM 428