Re: Anchor roller


Dan Carlson
 

I second Karen's recco.

Our pin broke/fractured just inside. 

A machinist ground the outside welds of the he pin and it was all removed in less than 10 minutes.

He then cut two SS washers from 2 inch round stock, approx 2mm thick and milled it for the exact size of the replacement pin. He welded these onto the sides to give lots of reinforcement and the fabricated a new removable pin.

I believe that the welding made the original SS pin brittle causing it to break over time.

Best regards, Daniel Carlson on sv BeBe, sm #387


On Mon, Oct 5, 2020, 1:33 PM Craig Briggs via groups.io <sangaris=aol.com@groups.io> wrote:
... and the shaft cannot rotate with the roller and wear against the side holes.
--
SN68 Sangaris, Tropic Isle Harbor, FL

Join main@AmelYachtOwners.groups.io to automatically receive all group messages.