Note: groups.io will be down for maintenance on Wednesday, October 5th, starting at 9AM Pacific Time (4PM Wednesday October 5, 2022 UTC), for approximately one hour.
Re: Genoa Chain Plate bolts Leaking in aft hanging closet
toggle quoted messageShow quoted text
Your plan should get you sealed back up. I didn't mention my recommendations for a sealant since I assume that you have a limited selection to pick from. The 5200 or 4200 will work for you. If you however can find the Polyether caulking called Multicaulk, sold in the States by West Marine, this would be my top choice because it does not seem to break down and turn gooey like the Polyurathenes can over time. Exposure to any kind of oil such as diesel is a problem for Polyurathenes and accelerates the softening. The Multicaulk is a bit softer and more flexible than the Polyurathenes, even the 4200. The softeness is a benefit in the bond of the sealant. Exposure to oils can temporarily soften the Polyether but as the oil is washed away, the polyether tends to return to it's original cured state. I have had complete failures with 4200 (and 5200 would be no different) from painting over the caulking seams on a wooden hull with traditional oil paints. Polyether caulking can be painted or vanished over without problems.
Best of luck,
From: Ken Powers SV Aquarius <ken@...>
Sent: Wed, Oct 14, 2020 5:04 am
Subject: Re: [AmelYachtOwners] Genoa Chain Plate bolts Leaking in aft hanging closet
Thanks to all you Amelians for helping me through this mess! I think I have a good procedure for the repair now. But as aways, subject to change once I get into job. It looks as though it should take all of 3 hours to complete this task, but as boat jobs go, I alway grossly underestimate time required 'til completion.
So, here is my revised plan of attack for this
1. Remove 1 or 2 of the bolts. Not to remove the entire chainplate.
2. Clean hole and bolt with acetone.
3. Verify no damage or pitting to the bolts.
4. Tape off area that I don't want to be covered in 4200.
5. Put good amount of 4200 into hole. Use a small toothbrush or q-tip to make sure that 4200 is completely covering the walls of bolt hole.
6 . Replace bolts and nuts.
7. Repeat (1 to 6) until finished with all the bolts. Except, I am only planing to do the 4 bottom bolts under the rub rail, not the single bolt in the middle of the chainplate. This bolt does not show signs of leaking, and even if it did, the leak should be at most, minor, due to the location. Unlike the 4 bottom bolts which could submersed in water for extended periods of time under the rub rail rubber.
8. Glue interior back together. Planing to use 3M Super 77 Spray Adhesive. This part should be straightforward.
9. Replace Rub Rail rubber piece. Using lots of soap and a bit of water!
If anyone has any suggestions, or reasons why I should change the process, let me know?
Thank you all!!
In Krabi Boat Lagoon, Thailand