toggle quoted messageShow quoted text
Here is the best description of a swap I've seen.
Teun - do you have any photos of that setup? Which pump did they use?
I think it would be easier on the Onan since I believe it's constant RPM regardless of load, so presumably that means the original Sherwood water pump outputs at a fixed flow rate. Find an electric pump that outputs the same and you're set.
The D3, regardless of revision, has a belt driven water pump that will output more water at 2800rpm than 700rpm. Outputting the max all the time may have unintended consequences and of course outputting the minimum may lead to overheating or worse.
On Wed, Feb 10, 2021 at 7:49 PM Teun BAAS <teun@...
Although not the water pump on my D3 110H
but my A54 has an @ time of construction AMEL yard installed separate
electric water pump for the ONAN genset and removed the impeller completely.
Best Regards Teun
SV AMELIT A54 #128
In Storage on the hard in COOMERA (near BRISBANE) QLD AUSTRALIA
February 10, 2021
USA cell: +1 832 477 8842
AUSTRALIA cell: +61 5951 8909
You can follow AMELIT via this link:
A friend owns a large trawler and he had identical problems with his water pump. He circumvented the problem by removing the drive belt and the internals of the unit and replaced it with an electric pump wired into the battery charge alternator.
Surely, some of the smart owners here could design a system which will work on 54’s equipped with Volvo D30...
Jean-Pierre Germain, Eleuthera, SM007, NZ.
We all agree it is daft that the 12v alternator is located directly below the raw water pump. It is a question of when not if it starts to leek as the lip seal eventually wears a groove in the shaft, but we are where we are.
The good news is that it will start to drip very slowly. So I stuff a clean rag below the pump and regularly inspect it for salt crystals. If the rag is dark in colour the salt shows up, otherwise one can taste it for salt. When the dripping
starts the rag will absorb the water and dry from the heat of the engine before any damage is done. This is the moment to service or change the pump. If you ignore the drips then sure enough it will end up getting worse and damaging the alternator. By the
way, getting that alternator off is bloody business literally.
Nick locked down in the UK whilst
Amelia AML 54-019 is in Leros Gr.
Can a drip shield be fabricated to keep seawater off the alternator?
Salatino A50#27, Speed of Life
I had a leaking D3 seawater pump. Unfortunately I discovered it too late. The seawater was already dropping on the Alternater and demaged the alternator (it's stupid from Volvo to position the alternator directly under the seawater pump!).
The cause was a worn shaft in the sea water pump. I had to replace both: seawaterpump and alternator! My mechanic suggestet not to do the shaft repair, but to install an new one.
So be carefull: If it's the shaft, it will ultimately ruin the alternater if not changed. The alternator was much more expensive than the pump...
Greeting from Vienna,
2007 A54 #69