as I'm not on board, may I have please your new support
dimensions (mm) with photo, if possible,
to better understand "I cut a slot in each side of the U
section to match the grating." ?
sv EUTIKIA SM428
the boat on the hard at Cleopatra Marina _ Preveza (GR)
Il 22/09/2020 05:53, Alan Leslie ha
I drilled the hole in the bottom of the U section...this is the
part that supports the stove top grating. I omitted to say that I
cut a slot in each side of the U section to match the grating.
The U section sits on a short piece of stainless tube and the
screw goes through the U section through the tube piece and into
the stove top.
It replicates the original plastic things that eventually melt.