Re: [Amel] SM Max prop anode excessive wastage
On mt Amel Super Maramu #376 Kimberlite the engine is disconnected from the
ground by a gold Valeo contactor except when the engine is started. My
engine is not grounded. However I always hang a Zink over the side and it
gets quite eroded over the season.
Amel Super Maramu #376 Kimberlite
[mailto:amelyachtowners@...] On Behalf Of Richard03801
Sent: Sunday, February 06, 2011 8:47 AM
Subject: Re: [Amel] SM Max prop anode excessive wastage
Put a volt meter on the shaft and ground it to the engine. If you get a
reading check the engine ground first. You may also get the sinks on the
prop working against those on the rudder. You might ck the condition of the
ground wires to the rudder. Are you using your ssb more then normal that can
also have an effect. Good luck. One last thing the metal content on the
zinks can also have an effect.
Regards in Annappolis SM 209 for sale.
On Feb 5, 2011, at 10:53 PM, "crwggb" <crwggb@...
<mailto:crwggb%40yahoo.co.uk> > wrote:
My max prop anode on SM140 has recently been suffering from excessivewastage. She is not in a marina or plugged in to shore power. The 2 anodes
on the rudder are performing "normally". The only recent change to
electrical equipment was a new nautic boiler, (wired in as per the original)
but that shouldn't affect the prop anode.