I attach it to the bonding clamp on the gas fill in my starboard cockpit
locker. That is also where I stow it when I am sailing.

At anchor the wire fits well under the locker gasket and I tie the zink to
the rail.

Fair Winds

Eric

Amel Super Maramu #376 Kimberlite





_____

From: amelyachtowners@...
[mailto:amelyachtowners@...] On Behalf Of Richard Piller
Sent: Sunday, February 06, 2011 5:32 PM
To: amelyachtowners@...
Subject: Re: [Amel] SM Max prop anode excessive wastage





Eric, what to you attach the boat side of your zink too??
Richard SM 209

________________________________
From: kimberlite <kimberlite@...
<mailto:kimberlite%40optonline.net> >
To: amelyachtowners@...
<mailto:amelyachtowners%40yahoogroups.com>
Sent: Sun, February 6, 2011 5:23:01 PM
Subject: RE: [Amel] SM Max prop anode excessive wastage

On mt Amel Super Maramu #376 Kimberlite the engine is disconnected from the
ground by a gold Valeo contactor except when the engine is started. My
engine is not grounded. However I always hang a Zink over the side and it
gets quite eroded over the season.

Fair Winds

Eric

Amel Super Maramu #376 Kimberlite

_____

From: amelyachtowners@...
<mailto:amelyachtowners%40yahoogroups.com>
[mailto:amelyachtowners@...
<mailto:amelyachtowners%40yahoogroups.com> ] On Behalf Of Richard03801
Sent: Sunday, February 06, 2011 8:47 AM
To: amelyachtowners@...
<mailto:amelyachtowners%40yahoogroups.com>
Subject: Re: [Amel] SM Max prop anode excessive wastage

Put a volt meter on the shaft and ground it to the engine. If you get a
reading check the engine ground first. You may also get the sinks on the
prop working against those on the rudder. You might ck the condition of the
ground wires to the rudder. Are you using your ssb more then normal that can
also have an effect. Good luck. One last thing the metal content on the
zinks can also have an effect.

Regards in Annappolis SM 209 for sale.
Richard Piller

On Feb 5, 2011, at 10:53 PM, "crwggb" <crwggb@...
<mailto:crwggb%40yahoo.co.uk>
<mailto:crwggb%40yahoo.co.uk> > wrote:

My max prop anode on SM140 has recently been suffering from excessive

wastage. She is not in a marina or plugged in to shore power. The 2 anodes
on the rudder are performing "normally". The only recent change to
electrical equipment was a new nautic boiler, (wired in as per the original)
but that shouldn't affect the prop anode.

Any one else had this problem, if so was there a quick fix?

Graham
SM140