Re: [Amel Yacht Owners] Re: 220Volt Power
Why don't you just disconnect the European connector and install a 50toggle quoted messageShow quoted text
amp 220 volt connector and return the expensive "y" connector and cord?
From: rossirossix4 [mailto:firstname.lastname@example.org]
Sent: Saturday, December 13, 2003 6:24 PM
Subject: [Amel Yacht Owners] Re: 220Volt Power
I had a few AC related questions and thought I would link them to
this earlier discussion about AC power.
I've purchased a Marinco "reverse Y" for my 1993 Santorin and have a
couple of questions. The boat has a 220 cord in its lazarette with
a French? three pronged male fitting on the end using three
straight,round contacts in a "v" arrangement. The plug is labeled
10 amps. Does any one have any recommendations for how to mate it
with the "reverse Y" female plug?
The 220 volt cord in the lazarette is not very long. I already have
one 50' 110v Marinco cord. It seems to make sense to just buy
another matching cord and connect the "reverse y" closer to the boat
or even in the lazarette with two 110 cords. Does anyone have any
advice on this?
I've been told that ABYC standards require a breaker within just a
few feet of where AC power enters the boat. Mine doesn't go through
a breaker until it gets to the GFI breaker in my galley panel. Any
thoughts on this?
Thanks, Bob "Hanalei"
--- In email@example.com, kimberlite1212
the amel plug has 3 wires a green and yellow and two hot 110 volt<edmundsteele@e...>
atheircommon and a ground wire. Many boaters (the majority are power
Thesevessels as two separate cables. For the Amel, we simply plug the
aoutlets are of opposite phase so they can be combined to produce
time.220 volt supply. This is the inverse of the "splitter" mentionedsells
ableThis approach is also very limiting as you probably won't be
toconditionerstake enough power off the 110 volt supply to run air-
US$40without throwing it's breaker.USA.
butarea 50 foot 220 volt extension cord may cost near US$600. If you
notafraid of using a screwdriver, you can cut the plugs off a 110voltextension cord and replace the plugs with 220 volt plugs.
Yahoo! Groups Sponsor
com/Default?mqso=60178338&partid=4116732> click here
To unsubscribe from this group, send an email to:
Your use of Yahoo! Groups is subject to the Yahoo!
<http://docs.yahoo.com/info/terms/> Terms of Service.