Date   

Re: [Amel Yacht Owners] where do you store your tools?

Alexandre Uster von Baar
 

Good morning Ryan,
I had 2 sets of tools (1 for inside 1 for outside).
The outside was located in the cockpit storage.
Difficult to see on the 1st picture, but was in the white box covered by a black mat.
If you look from the left you see life jacket, then type 4 (which is on top of the scuba compressor), then come a white box for the tools. So easy to grab especially in the engine room.
I would first take the mat and put on the floor (ie cockpit) then put tools I use on.
http://www.nikimat.com/storage_compartment_clip_organization.html
Actually here on the 9 and 10th picture you see the tools.
http://www.nikimat.com/cockpit_locker_storage.html
Also some more in the boxes below.
Inside set of tools were under the floor board.
Sincerely, Alexandre



--------------------------------------------

On Sat, 3/24/18, Ryan Meador ryan.d.meador@gmail.com [amelyachtowners] <amelyachtowners@yahoogroups.com> wrote:

Subject: [Amel Yacht Owners] where do you store your tools?
To: amelyachtowners@yahoogroups.com
Date: Saturday, March 24, 2018, 3:18 PM


 









Hi all,I'm wondering
where you store all your tools.  I feel like most of us are
very handy, so we must have a lot of them.  I use many of
my tools on a near-daily basis, so I like to keep them
easily accessible.  I've filled both of the drawers
beneath the starboard settee, and I still have more tools
that need homes!  Is there some awesome storage place I
haven't thought of?  Where do you keep
yours?
Thanks,RyanSM 233 IterationBoston, MA,
USA


Re: [Amel Yacht Owners] Bowthruster spinning

Bob Grey
 

Paul, I did it 2 years ago, and apart from the one Allen key bolt behind the motor it was pretty straight forward and yes I believe the 54 and 55 have the same setup.,, 

I think the reason for dropping the thruster was to make it easier to stand in the hatch to hold the motor, there were some electrical cables to undo as well but I didn’t have a replacement guide, it was a trial by logic replacement process. It took about two hours.

On Sunday, March 25, 2018, 01:48, sharongbrown@... [amelyachtowners] wrote:

 

Bob,
Looks like the attachment didn't upload. I have now uploaded a file "Bowthruster flex coupling replacement.pdf"
Paul


Re: Rats!

greatketch@...
 

Although rats do love to chew on things, they do not chew on metal. Unraveling a stainless steel pot scrubber, and stuffing in around the edges would make a pretty good barrier, not interfere with air flow, be cheap, and easy to renew if needed.

Here in the Bahamas, keeping connected while moving around is pretty easy.  We have a Batelco sim card for the phone, and have had a useful connection almost everywhere.  Most of the more popular anchorages on the populated islands have coverage by Bahamas Wireless, and, of course, if we are in a Marina, they usually have wifi.  

Other than the Bahamas, we have had good luck with local SIM cards, and wifi.  When we do come across a place without any connectivity... we relax and enjoy the peace!

For greater reach on our wifi signal, we have a Wirie range extender which works well. www.thewirie.com  
 
Bill Kinney
SM160, Harmonie
Great Guana Cay, Abacos, Bahamas


Re: Amel SM2000 salon table dimension and yanmar impeller puller tool

greatketch@...
 

I can answer Question #1:  33 inches x 52 inches


Re: Rats!

Dean Gillies
 

This is how to catch Sammy.


Sent from my iPhone X


Re: Rats!

Duane Siegfri
 

The thing that really amused me about this is the marina manager made a big point about "We do not have a rat problem", followed by their history of rat problems (building next door demolished, construction at the marina, etc.), so I noted that Wanderer has never had crew, much less a rat problem, but we do now after docking in your marina...

I think we're going to be friends.
Duane


Amel SM2000 salon table dimension and yanmar impeller puller tool

James Cromie
 

I have two simple question to ask SM2000 owners:

1. What is the dimension of the salon table?  I am desiring to get a PVC covering to protect the wood.  


2. What are the specs. for the tool needed to pull the raw water impeller on the Yanmar turbo diesel model 4-JH3-TE.  


Albon, the Amel tech in Le Marin kindly let me borrow a puller that he had, though I'd like to have one on board, and I'm no longer on my boat to measure anything!


Thank you all. 


James

Soteria

SM2000 #347

Le Marin

 




Re: Rats!

Paul Osterberg
 

We have had a rat aboard on one of our previous boats, We notice one morning that it had eaten on all apples and most of the tomato’s. Obviously it had walked maybe 15 m on our stern line ( med mooring) aboard our vessel. We had it aboard for a few days before we got hold of a rat trap then We manage to caugt it with a standard spring rat trap rather easy.
From now one we always carry a rat trap. In the med we have on more than one occasion noticed  rat droppings in the cockpit, fortunately the rat has not been able to penetrate our moskito net. Have not thought of protecting the “entrance” behind the Amel logo.
Paul on SY Kerpa SM 259


Re: [Amel Yacht Owners] where do you store your tools?

Danny and Yvonne SIMMS
 

Hi Ryan,
I have two long plastic bins in the open floor tray under the chart table where I keep my need it now tools. Pliers screwdrivers, hammer, wire cutters shifting spanners etc etc Under the first blue floor nearest section l keep spare oil and fuel filters and vee belts and my grease gun. The second section has a big double sided bin with multitudinous screws of all sizes on one side and bolts on the other. Also a container with all sizes of stainless hose clamps Also a pack of sockets and ring spanners. The second blue floor first section has a wide variety of spares, hose connections etc. The forward section contains my serious tools in a bag. Plus two socket sets 3/8 drive and 1/2 inch drive etc etc. I keep my cordless drill and my 4inch angle grinder in the bottom of the aft cabin wardrobe.
Of course I have not listed all my tools.
Regards
Danny
SM 299
Ocean Pearl

Sent from my Vodafone Smart

On 25 Mar 2018 9:18 a.m., "Ryan Meador ryan.d.meador@... [amelyachtowners]" <amelyachtowners@...> wrote:
 

Hi all,
I'm wondering where you store all your tools.  I feel like most of us are very handy, so we must have a lot of them.  I use many of my tools on a near-daily basis, so I like to keep them easily accessible.  I've filled both of the drawers beneath the starboard settee, and I still have more tools that need homes!  Is there some awesome storage place I haven't thought of?  Where do you keep yours?

Thanks,
Ryan
SM 233 Iteration
Boston, MA, USA


Re: [Amel Yacht Owners] Bowthruster spinning

ya_fohi
 

Porter,

Yes absolutey. Sometimes you need to do a job you haven't done before and get lots of various advice, sometimes conflicting. They probably will all work in one way or another. I'm open to any input I can get from those more experienced than myself.

Cheers,
Paul
Ya Fohi - Amel 54 #98


Re: Rats!

Duane Siegfri
 

By the way, Bill is right about a motivated rats jumping ability.

We have a net slung above the cabinet between the galley and the dining settee.  The rat has been feasting on the fruit and veggies in the net.  To reach, it has to jump a good 30' and then climb the netting.  I have the feeling that's not a tough job for it.

We've taken to calling him Sammy...not sure why but now that it's on the boat it needs a name.  Peg is sure it's a female and about to birth a litter of hundreds!!!!

Duane


Re: where do you store your tools?

Duane Siegfri
 

Also, I keep a tool roll up with my "90%" tools (yep, 90% of the time one of these will do the job).

I keep it in the footspace under the navigation desk.

Duane


Re: where do you store your tools?

Duane Siegfri
 

I have all my tools and many of the sealants, and special greases, etc, in the first deck locker fwd of the companionway.  There are three separate compartments in this locker with enough room for:

1.  Electric bag with all the strippers, crimpers, solderers, and testers.
2.  Electric bag with connectors, shrink, spare wire, and other fittings.
3.  Large engine tool bag.
4.  Tool bag with rachets.
5.  Misc tool bag with woodworking tools, portable vise (very useful), etc.
6.  In the stern-most section I have large plastic zip-locs with supplies like:  wire ties, sealants, special grease, blocks & shackles, buffer, etc.

Duane
Wanderer, SM#477


Re: Rats!

Duane Siegfri
 

Bill,

I tried to gently pry the Amel Logo/plastic piece off, but they used a good sealant on it and I think I'll do more harm than good.

It seems like I could take some screening and some silicone and just glue it on.  It would come off easily when it's full of lint or kitchen grease and then I could renew it with new screen and silicone...what do you think?

And..as much as you are on the move, how do you keep in touch?  I'd be interested in hearing how you do that.

Thanks for your reply!

Duane
Wanderer, SM#477


Re: Rats!

Duane Siegfri
 

Alexandre,

Thanks for the advice.  We think of you often and hope that things are going as well as they can for you.  Terrible times for sure.  I hope something good comes of it!!!

Duane


Re: where do you store your tools?

Philippe Morel
 

Under the first step , in a toolbox . One of my friends , have made a superb woodcraft work with two drowers .
Easy and superb .
Philippe SM 238


Re: Rats!

greatketch@...
 

The suggestion we got was to use metal screening on those vents, under the logo plate.  If the boat is closed tight, they offer the only access to the interior for a rat-sized rodent.  A mouse is small enough it probably has a few other options.

If on the other hand you are living on the boat with hatches and such open routinely, it is REALLY hard to be really rat-proof.  Bottles on the lines help and every little bit sure helps, but much of the time boats are close enough to the dock for a motivated rat to jump onto the deck if it is below dock level.

When I lived in the San Francisco area I knew a young German guy who kept a boat on a mooring in Hawaii.  He spent winters there, and summers working on boats in the Bay Area.  He went back to the boat one year and found a rat had gotten onboard, almost certainly climbing the mooring line after a long swim.  It did many thousands of dollars worth of damage to wiring, hoses, and woodwork before it died.

Bill Kinney
SM160, Harmonie
Great Guana Cay, Abacos, Bahamas


Re: [Amel Yacht Owners] where do you store your tools?

Stephen Morrison <steve_morrison@...>
 

I keep two “quick grab” boxes on the shelf in the pass through.


I keep an assortment of frequently used basics in the chart drawer. 


And the bulk of everything else goes in a large Rigid brand box in the engine room. I find it adds a great landing spot for stepping into the engine room(much easier to step on than the yellow step) and it gives me a great seat for oil changes and most everything else I need to do in the engine room. 





Steve Morrison
SM 380 TouRai
Georgetown, Exuma



On Mar 24, 2018, at 4:18 PM, Ryan Meador ryan.d.meador@... [amelyachtowners] <amelyachtowners@...> wrote:

 

Hi all,
I'm wondering where you store all your tools.  I feel like most of us are very handy, so we must have a lot of them.  I use many of my tools on a near-daily basis, so I like to keep them easily accessible.  I've filled both of the drawers beneath the starboard settee, and I still have more tools that need homes!  Is there some awesome storage place I haven't thought of?  Where do you keep yours?

Thanks,
Ryan
SM 233 Iteration
Boston, MA, USA


where do you store your tools?

Ryan Meador
 

Hi all,
I'm wondering where you store all your tools.  I feel like most of us are very handy, so we must have a lot of them.  I use many of my tools on a near-daily basis, so I like to keep them easily accessible.  I've filled both of the drawers beneath the starboard settee, and I still have more tools that need homes!  Is there some awesome storage place I haven't thought of?  Where do you keep yours?

Thanks,
Ryan
SM 233 Iteration
Boston, MA, USA


Re: [Amel Yacht Owners] Rats!

Mark Erdos
 

Duane,

 

The best way we have found to prevent rats from walking the lines onto the boat is to use an empty one liter soda bottle. Place the bottle between the dock and the boat with the rope passing through the bottle, longways (punch a hole in the bottom of the bottle). The bottle will spin on the rope it a rat tries to walk it. We used electrical ties to act as stoppers to prevent the bottle from moving up and down the rope. It not a pretty solution but it works. Or, you can get a cat.

 

BTW – it is also good practice to spray about the dock cleats with bug spray to prevent roaches from boarding via dock lines.

 

 

With best regards,

 

Mark

 

Skipper

Sailing Vessel - Cream Puff - SM2K - #275

Currently cruising - Guadeloupe

www.creampuff.us

 

From: amelyachtowners@... [mailto:amelyachtowners@...]
Sent: Saturday, March 24, 2018 1:35 PM
To: amelyachtowners@...
Subject: [Amel Yacht Owners] Rats!

 

 

We've had the unwelcome visitor as a result of a West Palm Beach Marina.

 

I'm looking for all points of entry and wondered what others might have done about the exhaust behind the port side Amel logo panel, just even with the helm.  It has three round openings, I assume for the kitchen exhaust.  None of them have screens so a mouse or rat could climb in and exit around the fan blades.

 

Has anyone found a good way to put a screen around it?  Or maybe feel that it's not needed?

 

Thanks,

Duane

Wanderer, SM#477