Re: [Amel Yacht Owners] Goit Deck Hatch Lens Reseal
eric freedman
|
|
Re: [Amel Yacht Owners] Re: Interior wood quality
james Hosford
Thanks Bill, i agree i dont care for the light wood option in the new 55s, but thats ok those are way out of my budget any way. Was mostly interested in the difference between the sm and the 54 do prefer the dark wood and the more white fabrics of the 54 but wasn't sure if the 54 was as tried and true as the sm. Some things quality goes down as you get newer
toggle quoted messageShow quoted text
On Sep 21, 2018, at 8:25 AM, Bill Rouse brouse@... [amelyachtowners] <amelyachtowners@...> wrote:
|
|
Re: [Amel Yacht Owners] Re: Interior wood quality
greatketch@...
James,
Thanks--exactly what I was looking for. I have had a lot of practice with a cabinet scraper which will transfer well. We see very much what you describe with the fading of the wood around the port lights. We'd like to keep everything covered more, but we live on the boat full time so that is not always possible. Bill Kinney SM160, Harmonie Annapolis, MD, USA
|
|
Re: [Amel Yacht Owners] run away windlass
greatketch@...
Kent,
There is a write up of the wiring work I did on the windlass here: https://fetchinketch.net/boat-projects/windlass-wiring/ I haven't written up the changes I made to the sheet winch wiring yet, but it is on my to-do list :-) The previous owner of Harmonie protected the bow thruster wiring by putting 125 amp terminal fuses on each of the four 24V battery positive terminals. When I upgraded the battery bank, the new batteries were just a tiny bit higher, and the terminal fuses no longer fit under the cover. I replaced them with a single 500 amp fuse in the main battery wire before the shut down switches. That would blow before the cables to the windlass or the engine room melted down from a short somewhere. There is no power supply switch on the thruster, other than the main power switch. Not a perfect solution, but I'll live with it. Bill Kinney SM160, Harmonie Annapolis, MD, USA ---In amelyachtowners@..., <karkauai@...> wrote : Hi Bill, That’s probably a good idea, do you have pics of the installations and the parts/sources you used? I know there’s been discussion in the past about adding a fuse/breaker/interrupt switch for the bow thruster. Did you do that while you were at it? If not, what was your thought process about it? Thanks Kent Kent Robertson On Sep 23, 2018, at 7:03 PM, greatketch@... [amelyachtowners] <amelyachtowners@...> wrote: We added breakers to interrupt the power to the motors for the windlass, and jib furler and, more recently, an emergency stop system for the sheet winches for this reason. The previous owners of Harmonie had the same problem happen with a jib sheet winch--relay contacts welded themselves shut and no way to stop it without cutting the power to the whole boat. (On older SM's--like ours--the control box for the port side winch is way up high, inside the cockpit locker.) Bill Kinney SM160, Harmonie Annapolis, MD, USA
|
|
Re: [Amel Yacht Owners] Mechanics in Leros, Greece
ianjenkins1946 <ianjudyjenkins@hotmail.com>
Hi Ian ,
toggle quoted messageShow quoted text
Can you explain the issue with your Vetus coupling ?
Ian and Judy , Pen Azen , SM 302 Greece
On 25 Sep 2018, at 08:23, Ian Shepherd
sv_freespirit@... [amelyachtowners] <amelyachtowners@...> wrote:
|
|
Re: [Amel Yacht Owners] Winter location Greek Ionian
ianjenkins1946 <ianjudyjenkins@hotmail.com>
Hi Mohammad and Aty,
toggle quoted messageShow quoted text
Cleopatra marina in Preveza— we spent two winters ashore there . Excellent Ian and Judy , Pen Azen , SM 302 , Greece
On 25 Sep 2018, at 11:24, 'Mohammad Shirloo' mshirloo@transpacific.us [amelyachtowners] <amelyachtowners@yahoogroups.com> wrote:
|
|
Re: [Amel Yacht Owners] Winter location Greek Ionian
Marek Cho
Hi, Od: "'Mohammad Shirloo' mshirloo@... [amelyachtowners]" Do: amelyachtowners@...; Wysłane: 17:24 Wtorek 2018-09-25 Temat: [Amel Yacht Owners] Winter location Greek Ionian
|
|
Re: [Amel Yacht Owners] Winter location Greek Ionian
For storage ashore Preveza is good with two big yards Cleopatra and one next door.
toggle quoted messageShow quoted text
I left my last boat there and it was good. Nick Amelia (54)
On 25 Sep 2018, at 17:59, amh@... [amelyachtowners] <amelyachtowners@...> wrote:
|
|
Re: [Amel Yacht Owners] Winter location Greek Ionian
Andreas
Hi Mohammad, hi Aty,
I stay in the Marina Lefkada in Lefkda for many years. It is a very safe place with nice people and some companies, which can provide service. It might be not the cheapest place but I think the prices can be negotiated (ask Mr. Spiros Dallos, the manager of the Marina Lefkada). It is quite full in the summer but I think there should be places in the winter. There are 4 to 5 buses to Athens every day and some flights to different locations from the airport in Preveza (around 25 minutes away from the marina). They can also lift the boat out of the water but have limited space on the ground. The city of Lefkada is only minutes away and offers good supplies for most of the things one needs. There are several ship chandlers in town.
Many regards,
Andreas SM 229 Meaalofa, Lesbos, amh@...
Von: amelyachtowners@...
Hi everyone;
|
|
Goit Deck Hatch Lens Reseal
greatketch@...
Has anyone else had the need to re-seal the lens into one of the Goit deck hatches? I just had one pop loose. I've reset the lenses of other brands before, bedding them down in silicone, but just wondering if anyone knows of anything "unusual" about the Goit hatches? Thanks! Bill Kinney Sm160, Harmonie Annapolis, MD, USA
|
|
Winter location Greek Ionian
Mohammad Shirloo
Hi everyone;
We are looking at leaving our boat in the Greek Ionian for this winter. We would appreciate all input about possible locations. We will not be wintering on board, so we are mainly looking for a safe, secure and reasonable location. It would be nice to have some services available but it is not critical. Thanks in advance. Respectfully; Mohammad and Aty AMEL 54 #099 B&B Kokomo
|
|
Re: [Amel Yacht Owners] Steyr engine
Alexandre Uster von Baar
Definitely agree with Mark (as always),
toggle quoted messageShow quoted text
Therefore I would be concerned with the Volvo D3-110 lack of reliability, I am sure you have read the issues on this forum or the (FB) Amel Owner Group. Because of that, personally, and this is a tough one, I would be tempted with the Steyr and have spare injectors, fuel pump, etc. Therefore I would research if the Steyr also suffers reliability issues… we only hear of the D3 because most 54 were equipped with one, may be the Steyr are as bad… Alexandre --------------------------------------------
On Tue, 9/25/18, Markus scrapp@interia.pl [amelyachtowners] <amelyachtowners@yahoogroups.com> wrote:
Subject: RE: [Amel Yacht Owners] Steyr engine To: amelyachtowners@yahoogroups.com Date: Tuesday, September 25, 2018, 9:23 AM That is the point. I am sure AMEL can help with service but Steyr is well known here in Europe but in Panama or Cook Island? That it can be good choice unless it is maintenance-free and reliable engine Thx for comments Brgds MarekOd: "'Mark Erdos' mcerdos@gmail.com [amelyachtowners]" <amelyachtowners@yahoogroups.com> Do: amelyachtowners@yahoogroups.com; Wysłane: 15:22 Wtorek 2018-09-25 Temat: RE: [Amel Yacht Owners] Steyr engine Mark, I think the bigger decision really depends on where you plan to take your boat. One of the reasons boat manufacturers chose Yanmar, Volvo, Onan etc. is because of the global network of distributors. I think if I were in your shoes and were serious about these boats offered for sale, I would ensure I had a good comfort level about being able to service the engine and obtain parts in remote places. That is if you place to go to remote places. With best regards, Mark Skipper Sailing Vessel - Cream Puff - SM2K - #275 Currently cruising - Bonaire www.creampuff.us From: amelyachtowners@yahoogroups.com [mailto:amelyachtowners@yahoogroups.com] Sent: Tuesday, September 25, 2018 8:20 AM To: amelyachtowners@yahoogroups.com Subject: [Amel Yacht Owners] Steyr engine Hi, I am on market for Amel and there are two boats in which I am interested in. The question is about engine. Both got Steyr 140hp engine. As this is not very popular one in marine industry I wonder if were there any issues with this engine? Does it need any extra service or maintanence? Working hours are low as 1900h so does not look bad. I know Steyr as truck but not yacht engine anyway it had well opinion. Brgds Mark Ps It is my first time on such Yahoo group so if I've posted something wrong let me know.
|
|
Re: [Amel Yacht Owners] Steyr engine
Marek Cho
That is the point. Od: "'Mark Erdos' mcerdos@... [amelyachtowners]" Do: amelyachtowners@...; Wysłane: 15:22 Wtorek 2018-09-25 Temat: RE: [Amel Yacht Owners] Steyr engine
|
|
Re: [Amel Yacht Owners] Steyr engine
Mark,
I think the bigger decision really depends on where you plan to take your boat. One of the reasons boat manufacturers chose Yanmar, Volvo, Onan etc. is because of the global network of distributors. I think if I were in your shoes and were serious about these boats offered for sale, I would ensure I had a good comfort level about being able to service the engine and obtain parts in remote places. That is if you place to go to remote places.
With best regards,
Mark
Skipper Sailing Vessel - Cream Puff - SM2K - #275 Currently cruising - Bonaire www.creampuff.us
From:
amelyachtowners@... [mailto:amelyachtowners@...]
Hi,
|
|
Steyr engine
Marek Cho
Hi,
|
|
Re: [Amel Yacht Owners] Mechanics in Leros, Greece
Ian Shepherd
Hajo, good to meet you on the dock this morning! Welcome to Leros marina. For the benefit of others who might be considering coming here, I have asked around about the Amel knowledge within the mechanics group. I am told that Panayiotis is very knowledgeable. He is primarily an electrician, but he is also capable of dealing with most things Amel, including rigging. He was previously at Agmar Marine. My mechanic is Manolis who is winning the battle against the Vetus coupling! He seems to be very competent and thorough. With your arrival, there are now 7 Amels in the marina and another 54 at anchor outside. Regards Ian Shepherd SM2K 414 Crusader
On 25/09/2018 09:57, Amw amw08@...
[amelyachtowners] wrote:
|
|
Re: [Amel Yacht Owners] Mechanics in Leros, Greece
Hajo Hille
Hi to all supporters, Thanks a lot to all of you for the valuable informations. So I am not really at the right spot to let the planned work to be done. Yes, Bill, I had one of the best teachers 😃 to do the Bowthruster service and I will do it by myself. Best wishes to Judy. To Ian, maybe we 'll meet here in Leros Marina. Best regards Hajo SM 150 Serafine Leros Von meinem iPad gesendet
|
|
Re: Vetus K018 Suppliers
Alan Grayson
Thanks Bill, I have left them a message.
For Eric it is these. The little rubber donuts that go in the vetus coupling between shaft and transmission
|
|
Re: Vetus K018 Suppliers
greatketch@...
Also...
https://www.fisheriessupply.com in Seattle carries them--and lots of other good stuff! Bill Kinney SM160, Harmonie Annapolis, MD, USA
|
|
Re: [Amel Yacht Owners] Vetus K018 Suppliers
eric freedman
Hi , What is the Vetus K018? Fair Winds Eric Kimberlite Amel Super Maramu #376
From: amelyachtowners@... [mailto:amelyachtowners@...]
Sent: Monday, September 24, 2018 12:42 PM To: amelyachtowners@... Subject: [Amel Yacht Owners] Vetus K018 Suppliers
Hi All, i'm trying to find a supplier for the Vetus Kit K018 in The good ole USA but can't seem to find any. Vetus shop in the UK keeps popping up. Does anyone know where i can source them. Regards Alan Grayson Soon to be owner SM 406 Ora Pai
|
|