Colin, It sounds as though you are "on-the-hard" (unless you changed the prop and oil seal underwater), hence I'd recommend you simply drop the unit, turn it over to drain the old oil, refill and

Hi there, We installed a wind generator on top of the mizzen of SM299 and am very happy with it. Ours is a German made Super Wind, expensive but robust, and very quiet. We just never hear it. As to

Hi Peter, The unit is just a push fit, a tube about 5 inches long, possibly with an O ring ( don't remember).It just prised out with a screwdriver--or maybe screw an eye into the cork part and pull.

Hi Bill and Judy. Got it sorted! Many thanks for the advice. Launch tomorrow so will soon see if it works Peter [Non-text portions of this message have been removed]

Vito: I am definitely interested in the outhaul motor and gear box for the main sail. Also I am interested in the starter for the Volvo motor. I have the TMD22B motor but hopefully the starter is an

We have ours about 6 feet below the mizzen spreader. Easy to service and it looks like it belongs there as its a good compliment to the radar dome. A little problem with the mizzen ballloner, but

We have had a mizzen wind gen for the last 7 years.  Not an issue with noise or looks.  The bigger issue is your antennas.  You might think about putting those on a bar between the two aft stays.

Be careful a wind generator on the mizzen is particularly ugly !! JLUC CottonBay ------------------------------------------------------------------------ 02/05/2012 20:18, p.aebersold a écrit :

At wat price you sell : 1. Outhaul motor and gear box for the main sail Brand new from Amel never used. 2. Heat exchange for the onan 7kw genset 3. Prop for bow

Dear friends I noticed a small leak of gear oil from bowthruster prop today so removed prop and changed the rubber oil seal. Since all other seals were replaced 5 months ago before our recent trip, I

Hi Bill and Judy. Many thanks for the reply. The main problem is trying to remove the unit situated behind the cork without damaging the area. How did you do this? Peter

Hi Peter, when we fitted new sensors we attached wires to the inboard end of the wires to the old sensors before removing them. These in turn became the messenger lines for the wires on the new

Hi Jim   I am located in NY. My hull # was 283 she is an SM2000 year 2000   Briefly this is what I have   Outhaul motor and gear box for the main sail Brand new from Amel never used.   gaeteff 160

We are interested in your spare pigtail parts, what else do you have? SM2K #353 Indecent nz free <asm283@...> wrote:

Hi Veto, It's Jim DeSalvo again. I can also be reached by phone at 206 650-3901. SV/LIEBLING SM#207 ldesalvo@...

Hello Vito, I know you enjoyed your boat and now you are on to a different life. Thank you for your email. I am in need of most of the items you have listed. I am based on the west coat of the US

Hello Everyone After 11 years and many thousands of miles we have sold our SM 2000. After returning to the states I have many spares in storage for sale including brand new outhaul motor and gear

Hi All, We are trying to replace the sensors for the log, in the keel. Does anyone know how to run the new senders to the instruments? Any help would be much appreciated. Peter Killen SM Pure Magic

Yes, I had the same problem with our holding tank pipes too last year. I managed to free them with a combination of using an acid (guess it was an organic stuff) and a cable they use for pulling wire

Hello, I intend to install a Wind Generator on top of the mizzen. Now, there are two antennas, the longer ist most probably for the fastnet radio (navtex)and measures 150cm. If I install the generator