Dear Bill, I have replaced   the propeller twice using only a snorkel, I tied myself close to the boat ,so i did not move away. I used the weight of the diving equipmet to keep myself steady and also

Sorry it was disconnecting the drive shaft from the motorthat caused the problem we had. The drive shaft remains connected to the foot and propeller. Peter SM2K "MAIA" #293 in Malta.

Bill, I have used both methods. Twice or maybe three times in the 12 years of ownership I have used a diver (I don't have the equipment). He seemed to be able to do the job in around 20-30 minutes and

Yesterday I did something stupid and lost the bow thruster propeller, or at least I think that's what happened when a line got entangled with the propeller. My question is to someone who has had to

Richard, Where is this rubber replacement to be found? George and Kim Cerillo SM2K #353 Indecent Sent: Friday, June 01, 2012 9:53 AM To: amelyachtowners@... Subject: Re: [Amel]

Hi Kent, The fixture on Revelation SM390, as Bebe's, is an AquaSignal. It's no longer made. If you have the same fixture, there are two tabs that actually hold a threaded plastic ring that holds the

Great, thanks, kent To: "amelyachtowners@..." <amelyachtowners@...> Sent: Wednesday, June 6, 2012 2:33 PM Subject: Re: [Amel] Re: Foredeck Light/Steaming Light   Hi Kent,

Hi Kent, yes it was. Without looking at it my memory is that it was denoted 12 to 30 volt, not just 24. In fact most of the bulbs we use for 24 volt are rated 28 volt. But I do find that even in

Added photo showing location of water lift muffler -

I'll try them, too.  Thanks, Kent To: "amelyachtowners@..." <amelyachtowners@...> Sent: Wednesday, June 6, 2012 12:40 PM Subject: Re: [Amel] Re: Foredeck Light/Steaming

Hi Ken, we bought all our LED from sailorsolution.com Let then know it is for an Amel and they will guide you / Ann-Sofie S/Y Lady Annila SM 232 Present in Croatia Skickat från min iPhone 6 jun

Thanks, Christophe, I have thoroughly enjoyed my SuperMaramu for 5 years now.  Save those coins and I'm sure you'll have your Maramu one day. Kent To: amelyachtowners@... Sent:

I found the source of the reduced power to the windlass. It was the contact points inside the windlass control box. I took photos and documented the steps I took to solve this. I will post more

Hi Danny, Is the LED that you bought at automotive store 24v?  Everything I'm finding online is 12v. kent To: "amelyachtowners@..." <amelyachtowners@...> Sent: Tuesday, June

Thanks, Danny and Alex. I'll see if I can find the LED you're talking about.  I found that AquaSignal is a subsidiary of Glamox and have asked them to help me find the off-white Kiel deck light

Hello Kent, try this. aqua signal GmbH Von-Thünen-Str. 12 28307 Bremen, Deutschland Postfach 45 01 61 28295 Bremen, Deutschland Telefon: +49 421 4893-0 Fax: +49 421

Hi again, Amel family, I looked for the Plastimo fixture after being pointed in that direction by Joel.  Couldn't find the fixture that I have on KRISTY, but bumped into this Kiel Deck Light by Aqua

Ross, Re-check the instalation manual about the hose size. The outlet from the engine is 3" but you may also go larger. I have a 75 HP Yanmar recently fitted in a non Amel boat by the local Yanmar

Thanks for all your feedback - we have used Trans Atlantic for spares previously and also experienced excellent service. Serge will reconsider dropping the filter to below the waterline !! Kindest

Hi Conn and Kirsty, Sounds like you bought your boat from the right guy. That's a great install. I agree it wouldn't be hard to duplicate but definitely some work. Where are you located? Weather here