Thanks Alex.

Happy New Year Kent! Are you going to cut the carpet yourself or is did you supply the old carpet as a pattern? Do you have the product details? Terry

The Rigging is original and will be replaced within the next 12 months. Do you have any advice/suggestions? We are based in San Diego.

Hello, Testing engine room ventilation today with shore power unplugged, I found the following: 1/ Main Yanmar engine ON, Onan Cummins Generator OFF: (a) A blower pumps air from somewhere port side

Hi yes I'm in town with the exception of Tues AM, and I'll be on the road Fri. Regards Richard Piller Cell 603 767 5330 [Non-text portions of this message have been removed]

Can any one help with the Perkins part numbers of the exhaust elbow and connector on the Prima 80t. ? Graham Boyd SM140 Sula Hong Kong

This is a peculiarity common primarily to the Super Maramu although I have experienced it on the Santorin. If the rig is tuned tight and proper, try completely easing the jib halyard when the boat is

Richard, Happy New Year! Are you in town/ office this week? Perhaps I can take you to lunch. Let me know what your schedule will allow. Sincerely, Scott Stusek | Marketing and Sales PANTAENIUS

Hi at about 12 kts the mast will setup a harmonic the comes and goes all is well. ALL OF THE STAYS must always!! Be tight. They should ring not go thud when hit with a wood hammer handle and the

Which Volvo is it? If it is the TMD 20, it is based on a Perkins and parts are available cheaply online as these engines were in Ford vans etc. Good luck Jean-Pierre No Amel yet! Jean-Pierre

Following Volvo service manual requires the waste gate on the turbo to be checked for movement. Last year it was stuck. Wd40 and a couple of days thinking about it had it freed off. This year I just

--- In amelyachtowners@..., "Alex" wrote: > > Can anyone share information wether the KANZAKI KMH4A gear box that is supplied with some Yanmar engines can be used to run a shaft

Hello Terry. I´ve worked with carpet all my life. I suggest you replace carpet entirely. Getting a carpet with a foam backing may be difficult unless you find some leftovers at some store. There are

I have just ordered new carpeting for Kristy. It is meant for marine environment, and has a special backing that is not supposed to deteriorate. It is made by Shaw Carpets. I have not put it in the

We are looking to replace either the backing our the entire set of carpets in Libby. The foam backing has deteriorated and is crumbling and peeling off the carpet. Has anyone replaced the backing or

Having owned Libby (SM197) for a year now and about 2000 miles of Pacific under her keel we have one phenomena that we need guidance on. While tied up at the dock we consistently notice the main Matt

Bill, I believe that the fluxgate compass, and rudder reference transducer are the same on the 300, the 400, and the 400g. Fair Winds Amel Super Maramu #376 Kimberlite Eric _____

Thanks Eric, you answered my questions, I think... Before posting, I emailed Raymarine with compatibility questions regarding the existing components which are not "plus" components. My reason was

Did he contact Ray marine? Many times they have, factory reconditioned units, also the newer model 400g Is a wire for wire change. 20 minute job there are two complete corepcaks and 2 course

I have a friend that is looking for a Raymarine 300 course computer. Since this particular course computer was on many Amels, I thought possibly someone had a spare they would like to sell. Let me