Thanks, Bill.  Nice! Kent ________________________________ To: amelyachtowners@... Sent: Friday, August 23, 2013 1:22 AM Subject: Re: [Amel] Solar panels for Amel Super Maramu

Hi Alexandre, and Bill, Yes, of course it is OK to use my name. Thanks for the pics, now I will have to wrap my old bones round the gen set and make the replacement. By the way buy the replacement

Hi Alexandre, Yes, of course it is OK to use my name. By the way buy the replacement capacitor in an electronics shop for €4 or 5 or get the same one from a Climma agent or other aircon mechanic

Kent, they were not rigged when that photo was taken. They are rigged now and work well to raise the dinghy and also the passerelle. Regarding the weight, it did not seem to make a noticeable

Just added some pictures to: http://nikimat.com/engine_room_fans.html John, let me know if this is ok to mention your name. Sincerely, Alexandre --------------------------------------------

Mine was out of range as well. Just changed it, but will start the genset next week. I am prety sure it will be the same result as Bill! --------------------------------------------

I have with great success used a glue named Eurocol 322 It is a kind of a water-based rubber glue that is very easy to apply. You need only to apply on one side, wait for 10-20 minutes and then

Hi, Bill, I don't see any lines for davits.  Is your arch a dinghy davit as well?  If it's not, why didn't you add that capability?  I would like to have davits for most island hopping and

Bill, Your arch looks terrific - good investment I think. I hope you will still be there on 5th Sept when I'm back in Goçek. Peter Peter Forbes 07836 209730 ppsforbes@... [Non-text

Gary, As I recall I used a cobalt drill bit for the hole in the race. Titanium might also work. Photos are posted in the album "Aletes SM#240" which may help clarify the process. I was not concerned

Sorry, the link did not work on the 220V Fan photo, but I tested this one and it works:

The link for the photos did not work...this will: http://groups.yahoo.com/group/amelyachtowners/photos/album/1515064489/pic/list Bill BeBe

I just posted photos of the Emek Marine solar arch installation which is about 90% complete. 3 X 140 Kyocera

Good morning Gary, thanks for the article and links. Sincerely, Alexandre --------------------------------------------

John, I want to thank you for pointing out the 2 mfd capacitor on the 220V exhaust fan. I had a feeling this exhaust fan was turning slower, so I check the cap and yes it was out of spec. I replaced

Hi Mike: I actually tried to drill into the races but couldn't penetrate the hardened steel at all. My original plan was to tap some screws into the race and use a slide hammer to pull the races out

The numbers are one ach blade. If you deal with ab marine in the UA they are wonderful. Fair Winds Eric Amel Super Maramu #376 Kimberlite Here was his note for the rebuild kit. Dear Sir,

The approach that worked well for me to remove the race was to drill and tap 3/16" threads through the race and hub, insert short 3/16" bolts from either end until they touched at the interface, then

Hello Eric, I ask the diver to let me know the number, he couldn't find it. BUT, that now you tell me what to look for, so I see on the previous owner's note and finf my number is: AP3281 (Left Hand

Is there any way, you would share the info on the H6 auto prop? Pitch, diameter, etc. Thanks in advance, sincerely, Alexandre --------------------------------------------