Billie, I am the owner of 2005 Amel 54 #31, currently on the hard in Grenada. I am interested in your RIB launcher. Where are you? I am also curious about your B&G analog gauges. What did you replace

Does anyone know the size or reference for the brushes for the Leroy Somer electric motor for the outhaul/main and genoa? Stocking up spare. Actually I am looking for all of the size of the brushes

Are you talking about the bearings in the lower unit connected to the propeller shaft? Fair Winds Eric Amel Super Maramu #376 Kimberlite _____ From:

Does any one know for sure the bearing sizes for the bow thruster? I want to stock on spare parts. Thanks in advance. Sincerely, Alexandre SM2K #289 NIKIMAT Seabrook, Texas, USA

--- In amelyachtowners@..., "Billie" <harlowx@...> wrote: > > I have a RIB launch and recovery system if anyone is interested.It has a roller setup which goes in the center removable rear

Yes - I would be interested too. Amel 54 #035 Goçek - Carango Peter Forbes 07836 209730 ppsforbes@...

Billie, I would be interested in seeing your rib launch system. Thank you, Gary S/V Bozo Cinq, Amel 54 #44

I have a RIB launch and recovery system if anyone is interested.It has a roller setup which goes in the center removable rear life gate post.It's free and I can supply pictures. Also B&G analog gauges

I am currently updating the electronics in my Santorin 1993 and have taken out the quite well-known Valsat 03 GPS from MLR Electronique. The GPS was functioning perfectly when dismounted and is

Hey Amel Owners, I'm considering the Santorin and Sharki models, but have yet to be aboard one. I'm in Los Angeles and can easily travel to anywhere in So Cal if one of you owners is gracious enough

Good morning Terry ? Thank you so much for the info on the cost. How about the cost to repitch the blade? Thanks in advance. --------------------------------------------

Alexandre, here is what I paid. On visual inspection It does need a new bearing kit. All 3-blades bearings are worn & the blades loose on the hub. Cost for Bearing Kit - $851.83. Includes new

Hi Alexandre. I really do not have the specifics on what the original pitch and diameter was and now is. Geoff did consult with Brunton's in the UK and between them both figured out a profile that

Thanks, Bill.  I've read your earlier posts about CorrosionX and have used it extensively in my engine room.  Just thought this looks like an impressive product that may be effective in the marine

Kent, Microscopic corrosion on low voltage electronics will kill the item. I have revived, from the dead, about $10,000 worth of electronic gear by coating the electronics, boards, and everything

We are heading to the boat in early October after a trip to visit my future father in law in Budapest. Since my Marina is in the middle of NoWhere Virginia with virtually no stores in close driving

I've seen a commercial on TV about this product now distributed by RustOleum. It's really impressive on TV. I thought treating electrical and electronic equipment might help prevent corrosion.

I just finished servicing the cables on our -87 Mango. At the rudder the bushings were filled with a white powder, that I asume is from some kind of corrosion. At the wheel end, the grease in the

More than happy to help Giovanni. We are currently in Townsville and are intending to head to Morton Bay Brisbane for the summer, but we will just cruise around the bay as there are so many great

We left Libertad on the hard at the Bundaberg Port Marina from Nov 2012 to June 2013.  All boats on hardstand survived the cyclone/flooding of that season with no damage. Boats in the marina were not