I just sent this to Maud in LaRochelle and would be interested if any one had any comments. Dear Maud, A technical question. My SM no 140 has through hull fittings for the intake water in both the of

This morning is the first Amel related emails that I have had in about a week,and my spam folder is empty. Pat SM #123

Interestingly our previous steady flow of Amel site emails has recently ceased too. I wonder if this has something to do with the Yahoo site changes?? Will check my spam folder but don't think that to

I giveup, Photos areposted in the first Kimberlite photo section FairWinds Eric AmelSuper Maramu #376 Kimberlite From: amelyachtowners@... [mailto:amelyachtowners@...] On Behalf Of

_____ I am using the Free version of SPAMfighter <http://www.spamfighter.com/len> . SPAMfighter has removed 2589 of my spam emails to date. Do you have a slow PC?

HiDanny, I lookedat the amel yahoo page, and I seem to have received all of the messages. You can heckyour spam fighter folder to see if any of it is being blocked as spam. You justthen have to

Hi Eric, seeing this about spam fighter makes me wonder. We are getting very few amel owners forum emails recently, wonder if this has something to do with it . Regards Danny SM 299 ocean pearl

I willpost them to the photos section FairWinds Eric From: amelyachtowners@... [mailto:amelyachtowners@...] On Behalf Of Sailorman Sent: Wednesday, December 18, 20138:20

_____ From: amelyachtowners@... [mailto:amelyachtowners@...] On Behalf Of Kent Robertson Sent: Wednesday, December 18, 2013 7:57 PM To:

That link didn't work

kl14.jpgDCP01181.JPGDCP01179.JPG _____ I am using the Free version of SPAMfighter <http://www.spamfighter.com/len> . SPAMfighter has removed 51 of my spam emails to date. Do you have a slow

Greg, I was referring to the cutless bearing. We pulled the shaft out from outside after removing the prop.

Dave, Are you referring to changing the cutless bearing or the bearing in the stern tube? Did you take the shaft out backwards (towards the stern)? Greg Shea Sharki 133 Cap des Isles

Hi Greg When we had our cutless bearing replaced in Lagos in 2007 the yardfabricated a small item out of surplus bits of steel to take the weight of thepull when the bearing is removed, first grind 2

Greg, I think its probably similar to the Maramu. You will need to undo the coupler and remove the prop shaft. On mine, I found that none of the standard bearings were a good fit so I had to have one

I will be changing my cutless bearing in the spring. Having only changed cutless bearings on free standing skeg hung shafts, I am a total neophyte with the bearing encased in the structure of the

Kaj, I forgot one important thing. The Onan impeller fits on a "keyed shaft." I had the key wear down to the point that the impeller spun on the shaft. It was not obvious. I changed the pump and

Herbert it has two mounting holes, one on each side. They are upside down key hole shaped, so you just loosen the two screws a little and lift it out. Also, the wooden frame is just bolted from below,

Thx Ian We took into account to mount it below the sink because there is more space but maybe it is better how you did that. Not a lot of space there. Can you easy remove it? Herbert SN #120 Kali