Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the amelyachtowners group. File : /SHARKI 1987 "Gioconda"/after osmosis

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the amelyachtowners group. File : /SHARKI 1987 "Gioconda"/after osmosis

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the amelyachtowners group. File : /SHARKI 1987 "Gioconda"/3 years ago.JPG

Hi Kent, The U-bolt did have a lanyard fitted for holding the engine compartment cover upwards when servicing. The lanyard had a end knot which connected to a slot in the cover. Eugene

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the amelyachtowners group. File : /SHARKI 1987 "Gioconda"/bow.trusther.JPG

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the amelyachtowners group. File : /SHARKI 1987 "Gioconda"/main cabin.JPG

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the amelyachtowners group. File : /SHARKI 1987

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the amelyachtowners group. File : /SHARKI 1987

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the amelyachtowners group. File : /SHARKI 1987

Thanks, Ann-Sophie, that makes it clear. Kent

Hi Kent & Ann-Sophie We have this table and just love it. It is compact and stows away in a nice neat package. We mount it on the locker side on the permanent mounting bracket that takes up so little

The U-bolt is to attach your lifeline, we have one next the the wheel as well. You can turn the table around the pole that is attached to the rope-container (first arm), and you can swing the table

Hi, Ann-Sophie, I'm unclear as to the mounting bracket. Is it attached to the middle of the table so that it rotates? Can it be locked in any position? Can it be folded down out of the way, or must

We have mounted a Lagun table on the outside front of the rope-container below the mizzen mast. We choosed the large table and it works perfekt. It is always up. You can see it on www.noa.se and

We are looking for more details on how the cockpit table on the Super Maramu 2000 that is mounted to the rear of the captains chair is constructed. The standard cockpit table that came with our SM

Hi Kent, not sure I would say they are prone to malfunction, rather that they need periodic maintenance. On mine one blade had more pitting on the thrust bearing surface, less on another and none on

Post your HIN and I can tell you the whole story.

Danny, If my memory is correct, Bruntons recommends that AutoProp have a bearing kit installed every 1200 miles. Bill BeBe, SM2k 387

Hmmmm. That's very informative Danny. Back when I had the TMD22 the blades seemed to spin freely on the hub so I assumed it was OK. There was never any vibration from the prop either. It didn't

Hi Bill, I do around 2 to 300 hours a year so 800 to 1200 hours. There is a lip seal outside the bearings. When I do my regular greasing and push the old grease out with the new it has no obvious