I was going to ask , if putting a lower and a higher hole would be a good way to go. I think it makes sense. What type or weight of grease should be used? Thanks, Pat

The capacitor on my 220v low pressure water maker pump went poof. I have purchased a replacement but the original does not seem to have any markings. Does it matter which way I wire the new capacitor

And the early worm gets the apple! Kent, send me an e-mail to svperegrinus at the company that provides this forum dot com and we'll take it from there. I'll pack it up Monday or Tuesday and figure

I am interested in one or both of them. One of mine died last year and I haven't replaced it yet. Kent SM 243 Kristy On the hard in Fernandina Beach FL

From S.P. Radio A/S, Aalborg, Denmark. The manufacturer stated these units were very low noise and ideal for powering radios. Working perfectly, we took two out of Peregrinus last week. One was

I love the St. Michael's area. It's a great town, I think has room for several boats either at the dock or anchored just offshore. What about that for a rendezvous place? Kent SM243, Kristy

Erick of sm376 wrote: «I forgot to mention that about 5 years ago I checked the grounding strap that is connected to all of the bonding in the engine room. It is in the wet bilge and is made of

Just don't make it July 26, that mine and viki Wedding Day. We are actually getting married on the boat in the Marina.

Mike, We knew you moved from the Sassafras to Rock Hall. I think to be fair, we need to be as central as possible , while still having a good anchorage and a beautiful and interesting place for

The pressure valve is easy to replace, but not necessary all the time. Try opening it up and popping it off a few times. That usually does the trick. John "Moon Dog" To: amelyachtowners@... From:

After DE-winterizing our santorin i discovered that the pressure valve is leaking each time the hot water tank is fill by the fresh water pump. The heating element is not hooked up so do i need to

I haven't done it yet, but I wouldn't use stainless plugs in the aluminum housing, I'd use nylon bolts. Kent

Hi Mark, When drilling put a cork on your drill to limit the depth it can go to, about your estimate of the thickness of the wall you are drilling through, if you don't get through, cut a bit off the

Eric, Thanks. Adding grease to the drill bit and tap makes sense. I also think the nylon bolts might be a better idea. Thanks again. It is always best not to mix metals. I was thinking that the

Yes, i have the same question, and any pictures would be awesome

Hi All, Hi all, Adding grease nipples to all furling gear housings is a priority on my to do list. I like the idea of having 2 stainless steel bolts with the same thread as the grease

Pat, Tom and I moved Aletes to North Point Marina in Rock Hall. It's in the northern bay, not central, but the marina is ideally situated for getting together. It's located at the breakwater with a