No Tony, unfortunately i'm too illiterate to write. Instead i shoot videoblogs. I started to upload them (slowly slowly) on facebook.yahya.karagoz.77 and some of them on amel owners page on facebook.

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the amelyachtowners group. File : /Leese-Neville Alternator Mod by Andrew

UPLOAD ISSUE - FILES It appears as though Yahoo was rejecting long file names when I attempted to upload a PDF to the Files section. When I shortened the name it worked. Thank you Jose for the

Hello Haldun, Did you write a blog about your experiences with the Amel 54 during your voyage ? I would love to read it if you did...... Regards, Tony Robinson - Catriona R Amel 54 no. 102.

https://groups.yahoo.com/neo/groups/amelyachtowners/photos/photostream Above is a link to Onan water-flow sensor maintenance. I was doing my weekly visual check of the engine room and found an

We used the aft locker on the stern for propane it's vented. We installed an Ele solenoid as well used copper lines to the galley as well as a manual shut off. In addition we installed a Broadwater 3

Hi All, I'm seeking experienced opinions relating to upgrading/modernizing the old Eno stove with campgaz/butane and manual shutoff. The gas locker will not fit a US propane tank and even if I

I've changed it every couple of years. It always looks like new. Kent SM243 Kristy

The first time I serviced my windlass, I had a helluva time getting the gypsy off, found the keyway and key were damaged. I had them cut a new keyway which still looks good now. Good reason to

Thanks, Bill. I'm going to use the ones with two female threads and make my own studs. Kent

Eric, On BeBe the key is on the inner clutch cone, not on the gypsy. And, yes this key takes a beating if you do not keep the clutch cone greased. I grease the cone each year. Bill BeBe

How often do you change the change the oil in the windlass? Fair Winds Eric Kimberlite SM 376

I see the 3/8 gypsy at budget marine for 230 less boat owners discount if you have one. Do check the key on the gypsy, mine was quite bent last time I had it off. Fair Winds Eric Kimberlite SM 376

The cost in the EU is 300 euros Bill BeBe

I'm told that would cost $300-400. Would rather avoid that extra cost. Kent

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the amelyachtowners group. File : /Leese-Neville Alternator Mod.pdf

Bill, thank you so much for posting this treatise on anchor chains. I now know what my old chain is! I know what to ask for! I get it! I don't know where you found this info, Bill, but it mustn't

Hey Kent HT is generally what's been used by Amel for years I think you'll find that's more than adequate and you get the stronger chain to go along with that Regards Capt Richard Piller

I uploaded a PDF of that link I gave Kent for anchor chain to the files section. It is titled Anchor Chain, Galvanized dimensions and calibration.pdf Kent, if the gypsy is not marked, it is possible

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the amelyachtowners group. File : /Anchor Chain, Galvanized dimensions and