Here's the gasket material I found that works fine. It's enough to do two replacements. My first replacement in 2010 has dried out and needs replacement again after 5 years. Purchased at

I just finished replacing my diesel heater with a D4. The boat is a Sharki, marasmus, and SM's need the D5. Yes I had to modify the connection slightly to pipe air into the boat. Total cost was

Thanks Bill, I will endeavour to go and see him this summer. What does surprise me is that this happens at all. The hatch is not often left open for long periods and when closed

I'm back on the boat. I'll get the source and part no to you tomorrow. Kent SM 243 Kristy.

Hello! I think it's the same as a Ebersprächer Airtronic D5 they retail at about 1800 € in Sweden, they are very common boat heaters in Scandinavia, with silencer on both exhaust and air intake

I don't know about the SM's but on the Maramu, Amel was sourcing the companionway hatch seals from Citroen. Somewhere I have the part number but I was never able to find a source for it. I'm sure

Paul. I am currently fitting an espar heater on Kimberlite. I bought it complete on eBay from England. Postage to USA was only $69- heater was a model D5 and very inexpensive. Leaving for the boat

Paul, We are 75% complete on our circle of the world and currently in Sicily where we need heat. We did not need a heater until we were in the Med. The closest we got to either the south or the north

Hello! We plan to sail full time and hopefully all the way aroundthe world, the first two seasons we plan to spend in the Mediterranean, otherdestinations we will consider are US East coast up to NY,

Hi Merk Send me a photo then i can tell you where it fits, most probaly on the 24v panel, maybe the alarm light when the alternator (main engine) is defect. Regards Hanspeter SM #16 in Turkey Von

This being a recurring topic, here's a post from some time ago that may be of interest: "We replaced the delaminating wooden companionway with plexiglass - one of the best changes we've made as it

As always, thank you so much Bill! Will contact them! Have a great day, sincerely, Alexandre --------------------------------------------

Maybe the lights on the 24v panel? Kent

Mark, Can they be spares for the bulbs on the Yanmar gauges? ===I have replaced 1 of these Or, replacement bulbs for the 24V panel warning lights?===I have replaced 2 of these Or, replacement bulbs

Kent, The following is the last message that I can find that you posted on the subject: Sep 4, 2010 7317Re: Rép. : [Amel] The companionway gasket I've just received some samples of other belt

I am cleaning out some stuff and came across some miniature light bulbs that I have no idea what they go to. They were left by the previous owner and marked in French “ampoules voyants tableau”

Alex, Dessalator changed these belts in June 2008 with a DUO design change, so there is a belt size for before the change and a different one for after the change. If I were you I would email

Hi Gary, I replaced mine a couple years ago. I posted the source and model number. I can't search very well on my phone, but if you search for Kent companionway seal you should find it. If not I'll

Gary, When they were available I got one from Amel. If I recall correctly under the inboard side of the back of the seal there are some screws that held it in ln place. I do not remember how I got to

Good day to all: Has anyone successfully replaced, refurbished, or removed the rubber seal at the bottom of the companionway washboard. I know that this seal was an automotive part that is no