I have mentioned this before, but for the sake of those who did not see it, there is an alternative to drilling for a paddlewheel. Tinley Electronics in the UK manufactures a black box that coverts

Thanks Gary - very helpful. Best wishes Peter Forbes 00447836 209730

At the last Miami and Ft Lauderdale boat shows I spent a good deal of time with the B&G folks - both a product development engineer and sales team managers - all asserted that the Sonic Speed is no

Should be back in Huntington end of June early July. Lets hook up. Fair Winds Eric Kimberlite Amel Super Maramu #376

We have moved Gary's comment into a new topic so we can track this thread in future. On #332 our B&G Sonic speed has recently started playing up with readings either too high or too low randomly. We

Hi all, I need a little help please from the electrical minded people please. I’ll be the first to admit most of what was posted regarding Ground and bond circuits on this forum is over my head

Gary, I will be back on Brava June 2nd. Will you still be in St. Thomas then? I would love to meet up if we overlap. Derick SM2K #400 Brava Currently in Sapphire Beach Marina

Hi Peter: I just saw your post on the SSB whip antenna. The plastic mounting ball at the base of my original Amel fitted SSB antenna failed and was un-repairable. I was in St. Thomas, USVI at the

Hi Joel: Thanks for the expanded knowledge on the "sonic speed hose". I always thought the idea of chafe protection was a bit overdone by encasing the cable in a hose, but your explanation makes

Hello Group. This boat has an interesting story. The original owners/builders had a Sharki named Arc en Ciel (Rainbow) that I had the privilege of selling for them in Fort Lauderdale many (25?) years

Hello Bill, Gary and the group. That 'pipe' is there to bring the wires for the aft most sensor for the sonic speed inside the boat AND ABOVE THE WATERLINE. Since the aft most sensor is mounted deeper

Alan, There are a variety of pumps in the SM. I have the Reya 66b pump, formerly made by AMFA. It turns on at about 1.25 BAR and turns off at about 2 BAR. this seems to work fine. I believe the Square

Do we know what the standard factory high and low pressure settings are for the Square D pressure switch mounted on the fresh water pump in the Super Maramu ? Thanks Alan SV Elyse SM437 Gulf

Gianni, We are at Marina di Ragusa, Sicily. We leave the end of April for Malta for a haul out and antifouling, then we sail up the east side of Italy headed for Barcelona, then Gibraltar, then

Bill, Many thanks so 7 meters then - i will ask Amel Med for that. Peter Peter Forbes 0044 7836 209730 ppsforbes@... Carango Sailing Ketch Amel 54 #035 Gouvia Marina - CORFU, Greece

Ciao Bill, Great! ...I have to wait for test because very very high temperature here around, no wind and more than 35 dg! Where are you? G ----Messaggio originale---- Da:

Ciao Bill, Great! ...I have to wait for test because very very high temperature here around, no wind and more than 35 dg! Where are you? G ----Messaggio originale---- Da:

Gianni, To add pressure to the accumulator tank, use a bicycle air pump attached to the tire-type valve on the accumulator tank (the valve wil be under the black plastic cap). Pump it up to a pressure

Peter, I found this some time ago. I think it is the source used on Super Maramus...not 100%

Can someone kindly tell me the length or description or part number of the SSB HF radio anr=tenna which is normally on the rear starboard deck of the Amel yachts? Peter Forbes 0044 7836 209730 Carango