OK, John. I have not been on board a SM as early as yours...things changed through the model years. Facing the dining table the A/C is under the left rear corner seat. And since we have the 2 freezer

Thank you Bill for your immediate response, which suggested to me that I am most likely looking for the where the hose connects to the copper line going to the aft shower as the source of the leak.

Bill, Check your pump number again. I think it is 0132-0277. If so, a google search shows that pump available for $368 and the 0132-0281 repair kit available for $204:

The pump I have is part 123-0277, the "overhaul" kit was part 0132-0281. included are some pictures (Check photos). The problem is the schematic I have (provided by onan) which is the worst

Reid, What w/maker do you have now and how is it powered? Do you have a generator with 220v supply ? Pat SM#123

Eric, Do you own a Amel ? If so what model and power source is your watermaker ? I want to give it someone that needs it or could use it for parts .There was a few different models and they are not

Vladimir, This watermaker would have no parts that you could use on your new Amel. The price you were quoted was indeed a rip off. The seals should not be much more than $10 and perhaps less. Pat

Should have changed the subject line on the previous posting.

John, I cannot be much help because I have never done any water line plumbing on an Amel. On SM 387, there is a pair of copper water lines that are behind the back cushion on the dining table seating.

Kent, Do you have part numbers for all the shaft seals that are used on the boat.

Motion Industries in the USA has the c-drive lip-seals 45x65x8 for $6.35. Mike S/V Aletes SM#240 Sent: Tuesday, September 29, 2015 6:43 AM To: amelyachtowners@... Subject: Re: [Amel

Do you have pump 132-0459 old# 132-0358 and rebuild kit 0541-1520/old# 0132-0380? You might want to consider this because the normal price is over $400 for that pump: [image: Inline image

Eric, Where are they located? What model of Caribe? Aluminum or Fiberglass...what length? What is the age of each? Does the motor run good? Bill BeBe

They sold me the prop shaft seals for $12 each with stainless springs about 6 years ago. That is a ripoff. Kent SM 243 Kristy

Pat. I will be in Annapolis this weekend. I would love to grab it if you haven't promised it to anybody eric 317-439-6492

Just bought a Nesting Sailing Dinghy http://www.nestinglite.com/ So my inflatable carib is for sale. I have a Tohatsu 2 Stroke, short shaft 9.8 HP engine that comes with it. I'm thinking 1200 for

Last winter was the first time for me leaving the boat on the hard. Evidently the fresh water line running between the pressure pump and the forward head has bursts or has a broken fitting. I see

Anyone have the rebuild instructions for a Onan 6.5 model MDKD? I have ordered the rebuild kit and there is no re-assembly instructions to go along with it. The old parts were in such bad shape that

I planned to use it on my Amel. I did not know that the water makers are of the different capacity. Are they made by the same manufacturer? It it is so then some parts are similar. Carolina Seals

Good evening Kent, That sounds good! I can bring some champagne or sparkling wine and show you how to Saber the bottle! Plus a tour of each other vessel!!! I haven’t reserve yet, but I should be