|
Re: [Amel Yacht Owners] Re: 24 volt charger on Yanmar quit working causing DC panel light to indicate fault
I will get that book.. Someone else recommended it as well.
Ben Driver
La Bella Vita
SM #347
I will get that book.. Someone else recommended it as well.
Ben Driver
La Bella Vita
SM #347
|
By
Ben and Gayle Super Maramu #347
·
#24838
·
|
|
Re: [Amel Yacht Owners] Shopping for an SM or SM2k
Have you talked to Joel Potter? If not, you should.
With best regards,
Mark
Skipper
Sailing Yacht: Cream Puff
www.creampuff.us
Have you talked to Joel Potter? If not, you should.
With best regards,
Mark
Skipper
Sailing Yacht: Cream Puff
www.creampuff.us
|
By
Mark Erdos
·
#24837
·
|
|
Re: [Amel Yacht Owners] Onan Cranks But Won't Start
Hi Gary,
I pretty much went through what you did. Also had the injectors rebuilt all to no avail. Even checked for obstruction BETWEEN the exhaust mixing elbow and the thruhull. Ultimately loosening
Hi Gary,
I pretty much went through what you did. Also had the injectors rebuilt all to no avail. Even checked for obstruction BETWEEN the exhaust mixing elbow and the thruhull. Ultimately loosening
|
By
Mike Ondra
·
#24836
·
|
|
Re: [Amel Yacht Owners] Onan Cranks But Won't Start
Hi Mike:
I am thinking that exhaust restriction is a possibility.
The fuel supply side checks out:
- New RaCore Filters prior to haul out and are clear
- Fuel topped up so condensation
Hi Mike:
I am thinking that exhaust restriction is a possibility.
The fuel supply side checks out:
- New RaCore Filters prior to haul out and are clear
- Fuel topped up so condensation
|
By
amelliahona <no_reply@...>
·
#24835
·
|
|
Re: Onan Cranks But Won't Start
Hi Alexander:
I verified that the engine fault breaker (CB2), generator fault breaker (CB5) were set and not tripping. Also the Engine Run/Emergency Stop red switch (CB4) is on. CB1 is the DC
Hi Alexander:
I verified that the engine fault breaker (CB2), generator fault breaker (CB5) were set and not tripping. Also the Engine Run/Emergency Stop red switch (CB4) is on. CB1 is the DC
|
By
amelliahona <no_reply@...>
·
#24834
·
|
|
Re: Onan Cranks But Won't Start
Hi Olivier:
Thanks for your reply. The starting battery (12 volt) has a small solar panel to trickel charge it while on the hard. Even so, for the few days we were in the yard I charged it with
Hi Olivier:
Thanks for your reply. The starting battery (12 volt) has a small solar panel to trickel charge it while on the hard. Even so, for the few days we were in the yard I charged it with
|
By
amelliahona <no_reply@...>
·
#24833
·
|
|
Re: [Amel Yacht Owners] Onan Cranks But Won't Start
Sorry to read about your problem Gary,
Read the other reply, did you check all the fuse/breakers, especially the "Field" were on?
Sincerely,
Sorry to read about your problem Gary,
Read the other reply, did you check all the fuse/breakers, especially the "Field" were on?
Sincerely,
|
By
Alexandre Uster von Baar
·
#24832
·
|
|
Re: [Amel Yacht Owners] genoa furler holding plate
Dear Olivier
Thank you very much for your explications. They are very helpful to me. I just got new sails from Qsails in Izmir, and of course I want to treat them right from the beginning.
Maybe one
Dear Olivier
Thank you very much for your explications. They are very helpful to me. I just got new sails from Qsails in Izmir, and of course I want to treat them right from the beginning.
Maybe one
|
By
danielmfrey63@...
·
#24831
·
|
|
Re: [Amel Yacht Owners] Onan Cranks But Won't Start
Good morning Gary,
the Onan sometimes starts with difficulties because of electric power (although the main engine starts easily).
Is your starter battery in good condition (how old is it?)? Did you
Good morning Gary,
the Onan sometimes starts with difficulties because of electric power (although the main engine starts easily).
Is your starter battery in good condition (how old is it?)? Did you
|
By
Olivier Beaute
·
#24830
·
|
|
Re: [Amel Yacht Owners] genoa furler holding plate
Hello Daniel,
in fact, you should adjust the tension on all halyards according to the wind conditions. The best way is to have a look at the luff (of each sail) when it is fully out and under load.
Hello Daniel,
in fact, you should adjust the tension on all halyards according to the wind conditions. The best way is to have a look at the luff (of each sail) when it is fully out and under load.
|
By
Olivier Beaute
·
#24829
·
|
|
Re: [Amel Yacht Owners] Onan Cranks But Won't Start
Hi Gary,
Think simple… if your engine starts then shuts down, it is likely a fuel problem.
Good luck,
Jean-Pierre Germain,
SY Eleuthera, Amel Super Maramu 007
Hi Gary,
Think simple… if your engine starts then shuts down, it is likely a fuel problem.
Good luck,
Jean-Pierre Germain,
SY Eleuthera, Amel Super Maramu 007
|
By
Germain Jean-Pierre <jgermain@...>
·
#24828
·
|
|
Re: [Amel Yacht Owners] Onan Cranks But Won't Start
Hello Gary.
Aletes’s Onan suffered similar symptoms this last spring after not being used for over 6 months. Check my posting Aug 1, 2015 “Onan generator will not run”. Carbon buildup at
Hello Gary.
Aletes’s Onan suffered similar symptoms this last spring after not being used for over 6 months. Check my posting Aug 1, 2015 “Onan generator will not run”. Carbon buildup at
|
By
Mike Ondra
·
#24827
·
|
|
Re: [Amel Yacht Owners] Onan Cranks But Won't Start
Gary,
One other thought. I almost hate to put this out there but is the fuel valve to the genset fully open?
With best regards,
Mark
Super Maramu 2000
Hull
Gary,
One other thought. I almost hate to put this out there but is the fuel valve to the genset fully open?
With best regards,
Mark
Super Maramu 2000
Hull
|
By
Mark Erdos
·
#24826
·
|
|
Shopping for an SM or SM2k
Hello all,
We have begun shopping for an SM or SM2k to continue our cruising plans on an upgraded platform.
We are currently in Hawaii, but would go almost anywhere for the right boat at the right
Hello all,
We have begun shopping for an SM or SM2k to continue our cruising plans on an upgraded platform.
We are currently in Hawaii, but would go almost anywhere for the right boat at the right
|
By
greatketch@...
·
#24825
·
|
|
Re: [Amel Yacht Owners] Onan Cranks But Won't Start
Gary,
A few ideas:
An obstruction in the exhaust or air intake
Faulty stop solenoid
Is the preheat working correctly
If you have bled the fuel system and have fuel in the lines to the
Gary,
A few ideas:
An obstruction in the exhaust or air intake
Faulty stop solenoid
Is the preheat working correctly
If you have bled the fuel system and have fuel in the lines to the
|
By
Mark Erdos
·
#24824
·
|
|
Re: [Amel Yacht Owners] 24 volt charger on Yanmar quit working causing DC panel light to indicate fault
Ben,
What engine and alternator do you have?
When you put a multi meter across the alternator terminals you are also reading the house bank voltage
if I am not mistaken. You might just have a bad
Ben,
What engine and alternator do you have?
When you put a multi meter across the alternator terminals you are also reading the house bank voltage
if I am not mistaken. You might just have a bad
|
By
sailormon <kimberlite@...>
·
#24823
·
|
|
Re: [Amel Yacht Owners] Re: 24 volt charger on Yanmar quit working causing DC panel light to indicate fault
Alternators are very rarely so destroyed that they can't be rebuilt far more economically that a replacement. Find a local alternator/starter rebuild shop. You'll find they can certainly test your
Alternators are very rarely so destroyed that they can't be rebuilt far more economically that a replacement. Find a local alternator/starter rebuild shop. You'll find they can certainly test your
|
By
greatketch@...
·
#24822
·
|
|
Re: [Amel Yacht Owners] 24 volt charger on Yanmar quit working causing DC panel light to indicate fault
Hello Ben:
Different engine on our boat, we had the ground cable to the alternator pretty much broke which caused the non-charging. Our friend (SM2k with yanmar) had the same...same cause.
We both
Hello Ben:
Different engine on our boat, we had the ground cable to the alternator pretty much broke which caused the non-charging. Our friend (SM2k with yanmar) had the same...same cause.
We both
|
By
Veit M <veitm@...>
·
#24821
·
|
|
Onan Cranks But Won't Start
Hi All:
My boat, SM #335, has an Onan 7MDKAL-431 Spec B, 7 kW genset. It has 2,300 hrs on it and it has been basically flawless with normal matinenance. 6 months ago I changed the oil, it
Hi All:
My boat, SM #335, has an Onan 7MDKAL-431 Spec B, 7 kW genset. It has 2,300 hrs on it and it has been basically flawless with normal matinenance. 6 months ago I changed the oil, it
|
By
amelliahona <no_reply@...>
·
#24820
·
|
|
1987 Maramu offered for sale
After 3 years of Caribbeancruising, we are deciding what to do next with our 1987 Amel Maramu,Languedoc. We leave Grenada in Feb.,destined for Puerto Rico in May.
Our original intent with
After 3 years of Caribbeancruising, we are deciding what to do next with our 1987 Amel Maramu,Languedoc. We leave Grenada in Feb.,destined for Puerto Rico in May.
Our original intent with
|
By
Curt Epperson
·
#24819
·
|