I have looked att the files concerning repair of the bow truster, but I can't find what size/specification of the lip seals. I urgently need to get hold of new lip seal especially for the side where

Hi Kent, I was thinking of replacing my engine mounts. You made a disk to align the engine. Do you have a drawing of it? I would like to make on. Fair Winds Eric Kimberlite Amel Super Maramu #376

Our 1985 Maramu "Chara" has a Rocna 33 and I needed to extend the anchor roller to make it fit properly. I've been happy with the holding. Bob

The 12 power is supplied by a converter in the cubby behind the aft door under the nav station. There is also a circuit breaker in the wet locker on the forward side that turns on the nav station.

On our SM2000, hull 353, I have lost power to my 12V and 24V receptacles at he chart table location. Can some advise me of the location of a breaker or a fuse that I can reset / replace to fix the

Dear Ian, dear Olivier, thank you very much for your valuable inputs! Best regards - Daniel SY Heureka SN 64 Kuşadası, Turkey

JP, You are in Europe, not in the Tropics. Bill BeBe 387

Good morning Mark, Thanks very! Will look at the wiring… Hope you have a great weekend! Sincerely, Alexandre --------------------------------------------

haaaaa.. sorry the auto correct... changed it uster@... or uster at rocketmail dot com Sincerely, Alexandre --------------------------------------------

I use a Rocna 33 on my Maramu #148 and have no complaints so far. Yes, it looks sooo big in the shop, but you hardly notice it when mounted. It settles quite well into the standard roll, though you

The new platform looks stable, easy to use, easy to search, and with articles generally well-classified by section (the poster chooses where to post). I for one will be moving over to

We tried to get someone in France to do the "hydro gommage' but we could not find anyone to do a boat as the boat would have to be put in a special part of the yard and surrounded by plastic - their

Jean-Paul, I have a Manson Supreme 60lb. Similar to Rocna - fits ok, just touches the pullpit upright when stowed. It's a very good anchor. This topic has come up before, try searching through

Thankyou Olivier for your learned advice Sent from Windows Mail From: 'Mike Ondra' mdondra@... [amelyachtowners] Sent: ‎Saturday‎, ‎13‎ ‎February‎ ‎2016 ‎12‎:‎54‎ ‎a.m. To:

Hi, I could not make out your email address. Thanks Eric

Paul, try me at wtstout at mac dot com. Will Anni Bea True SM180 St Martin, FWI

Hi JP, I had two nearly disastrous experiences coming unhooked with my old 60lb spade. Often had to try setting 2-3 times before it set. I got a Rocna 40kg which fits perfectly on my bow roller and

Alexandre, Yes. Carbon will build more rapidly on a diesel engine that is operated at lower RPMs or load. Regarding the wiring of the BlueSea 8731, it is wired to the 220 breaker panel.

My Maramu has 2 heads, but only one has a holding tank and valve. The forward head is overboard discharge only. Does on have to lock the door to the head, or put a chain around it? Has anyone

I also had a Spade anchor, the 100, but the shank bent slightly. The shank is hollow to keep all the weight in the lead filled tip. I sent photos to Spade asking about a replacement shank but never