|
Re: [Amel Yacht Owners] Bowthruster propeller shaft seal on SM
Paul,
You say, "..as it was still three nylon screws intact on the hub."
Was the hub still on the shaft of the bow thruster and the propeller broke off of the hub? I have seen this happen before with
Paul,
You say, "..as it was still three nylon screws intact on the hub."
Was the hub still on the shaft of the bow thruster and the propeller broke off of the hub? I have seen this happen before with
|
By
Bill & Judy Rouse <yahoogroups@...>
·
#25980
·
|
|
Re: [Amel Yacht Owners] Amel 55 layout
Do any of you know what to look for in a 54 of approximately ten years vintage? If we decide to go that route (which is still very much in the air -- 55 is still on the table, but I will miss the
Do any of you know what to look for in a 54 of approximately ten years vintage? If we decide to go that route (which is still very much in the air -- 55 is still on the table, but I will miss the
|
By
Kenneth Olsen <kennetholsen468@...>
·
#25978
·
|
|
Re: [Amel Yacht Owners] Amel 55 layout
Alex,
I agree completely. And, I will add that with the 55 Amel was attempting to compete outside the small circle of very loyal Amel clients. As most of you know, the majority of the 54's were sold
Alex,
I agree completely. And, I will add that with the 55 Amel was attempting to compete outside the small circle of very loyal Amel clients. As most of you know, the majority of the 54's were sold
|
By
Bill & Judy Rouse <yahoogroups@...>
·
#25977
·
|
|
Re: [Amel Yacht Owners] Re: Overcurrent Protection on Winches, Windlass, and Bowthruster
Kent,
Since Don has sold Harmonie to me (Thank you Don and Ann!) I will answer your question.
The fuses Don installed are on the positive terminal of each 24 volt pair of batteries. They are 125
Kent,
Since Don has sold Harmonie to me (Thank you Don and Ann!) I will answer your question.
The fuses Don installed are on the positive terminal of each 24 volt pair of batteries. They are 125
|
By
Bill Kinney <greatketch@...>
·
#25976
·
|
|
Re: [Amel Yacht Owners] Bowthruster propeller shaft seal on SM
Bill!
The hub and propeller was from a common friend in Turkey, Nothing wrong with the hub, but the propeller has obvious gone into pieces, as it was still three nylon screws intact on the
Bill!
The hub and propeller was from a common friend in Turkey, Nothing wrong with the hub, but the propeller has obvious gone into pieces, as it was still three nylon screws intact on the
|
By
Paul Osterberg
·
#25975
·
|
|
Re: [Amel Yacht Owners] Bowthruster propeller shaft seal on SM
Alexandre!
It was the propeller itself, the nylon hub with the screws was total intakt except three of he nylon screws that was broken
Paul on S/Y Kerpa SM#259
Alexandre!
It was the propeller itself, the nylon hub with the screws was total intakt except three of he nylon screws that was broken
Paul on S/Y Kerpa SM#259
|
By
Paul Osterberg
·
#25974
·
|
|
Re: [Amel Yacht Owners] Bowthruster propeller shaft seal on SM
Alex,
I know that you know this, but you did not mention the stainless steel pin that goes through the hub.
If that pin was inserted through the Delrin® hub and thruster shaft before the propeller
Alex,
I know that you know this, but you did not mention the stainless steel pin that goes through the hub.
If that pin was inserted through the Delrin® hub and thruster shaft before the propeller
|
By
Bill & Judy Rouse <yahoogroups@...>
·
#25973
·
|
|
Re: [Amel Yacht Owners] Amel 55 layout
Sounds interesting. This would be a great opportunity.
Could you ensure the new owner would be comfortable with such a thing? Also, see if my wife could join or just me.
Also, could you be more
Sounds interesting. This would be a great opportunity.
Could you ensure the new owner would be comfortable with such a thing? Also, see if my wife could join or just me.
Also, could you be more
|
By
Kenneth Olsen <kennetholsen468@...>
·
#25972
·
|
|
Re: [Amel Yacht Owners] Amel 55 layout
Greg -- thank you so much for the response. I truly appreciate your input.
Greg -- thank you so much for the response. I truly appreciate your input.
|
By
kennetholsen468@...
·
#25971
·
|
|
Re: [Amel Yacht Owners] Re: Overcurrent Protection on Winches, Windlass, and Bowthruster
Thanks every one. Don, did you use the 300A fuses ?
Thanks
Kent
Thanks every one. Don, did you use the 300A fuses ?
Thanks
Kent
|
By
Kent Robertson
·
#25970
·
|
|
Re: [Amel Yacht Owners] Bowthruster propeller shaft seal on SM
Good morning Paul,
I haven’t posted the detail on the forum yet, but I found both propeller with the 6 nylon bold still attached to it… there was also nothing in the water to cause the
Good morning Paul,
I haven’t posted the detail on the forum yet, but I found both propeller with the 6 nylon bold still attached to it… there was also nothing in the water to cause the
|
By
Alexandre Uster von Baar <uster@...>
·
#25969
·
|
|
Re: [Amel Yacht Owners] Amel 55 layout
After Mr Amel passed away I think the company tried to accommodate too much buyer idea of what their boat “should” be, often these people making mistakes.
To me Amel have always been offshore
After Mr Amel passed away I think the company tried to accommodate too much buyer idea of what their boat “should” be, often these people making mistakes.
To me Amel have always been offshore
|
By
Alexandre Uster von Baar <uster@...>
·
#25968
·
|
|
Re: [Amel Yacht Owners] Amel 55 layout
Ken, I have an Amel 55 with a single aft owners cabin, there are two designs of aft layout, but would suggest get the single aft cabin as I agree with you about a bow cabin being less comfortable
Ken, I have an Amel 55 with a single aft owners cabin, there are two designs of aft layout, but would suggest get the single aft cabin as I agree with you about a bow cabin being less comfortable
|
By
Bob Grey
·
#25967
·
|
|
Re: [Amel Yacht Owners] Bowthruster propeller shaft seal on SM
Hello!
Alexandre
I also lost my bow-thruster propeller after overhauling the whole thruster with new bearings and lip seal.
When in the water I used it less than 5 seconds and suddenly the revs went
Hello!
Alexandre
I also lost my bow-thruster propeller after overhauling the whole thruster with new bearings and lip seal.
When in the water I used it less than 5 seconds and suddenly the revs went
|
By
Paul Osterberg
·
#25966
·
|
|
Re: [Amel Yacht Owners] Amel 55 layout
Re Amel 55 layout et al.
Kenneth, I am very much in agreement with your assessment of the 54 vs. 55 layout.
If it can be of any help in forming your own opinion, or confusing you thoroughly, I
Re Amel 55 layout et al.
Kenneth, I am very much in agreement with your assessment of the 54 vs. 55 layout.
If it can be of any help in forming your own opinion, or confusing you thoroughly, I
|
By
Jean Boucharlat
·
#25962
·
|
|
Re: [Amel Yacht Owners] Amel 55 layout
Hi everyone,
I live on my Super Maramu but am also a broker for Northrop & Johnson representing Amel in Asia. The 55 can be configured either with two aft cabins both doubles or one huge owners
Hi everyone,
I live on my Super Maramu but am also a broker for Northrop & Johnson representing Amel in Asia. The 55 can be configured either with two aft cabins both doubles or one huge owners
|
By
Mawgan Grace <gashman@...>
·
#25965
·
|
|
Re: [Amel Yacht Owners] Amel 55 layout
Wow! Great timing for me. Thank you so much. I have to agree with your over-all position that marketing must have gotten too much power after the Master passed away. Although I have yet to own
Wow! Great timing for me. Thank you so much. I have to agree with your over-all position that marketing must have gotten too much power after the Master passed away. Although I have yet to own
|
By
kennetholsen468@...
·
#25964
·
|
|
Re: Overcurrent Protection on Winches, Windlass, and Bowthruster
I certainly like the way Amel designed the SM, or I would not have bought one. And this does not apply specifically to my boat, because the previous owner installed battery terminal fuses to cover
I certainly like the way Amel designed the SM, or I would not have bought one. And this does not apply specifically to my boat, because the previous owner installed battery terminal fuses to cover
|
By
greatketch@...
·
#25963
·
|
|
Re: [Amel Yacht Owners] Re: Overcurrent Protection on Winches, Windlass, and Bowthruster
I'm a believer, Bill, but I need insurance.
Kent
I'm a believer, Bill, but I need insurance.
Kent
|
By
Kent Robertson
·
#25961
·
|
|
Re: [Amel Yacht Owners] Re: Overcurrent Protection on Winches, Windlass, and Bowthruster
Thanks Alan, I was looking for a battery terminal fuse block with max amperage of 450A or so. The highest amp ones I can find are 300A max. If I can avoid mounting a fuse block somewhere, I'd rather
Thanks Alan, I was looking for a battery terminal fuse block with max amperage of 450A or so. The highest amp ones I can find are 300A max. If I can avoid mounting a fuse block somewhere, I'd rather
|
By
Kent Robertson
·
#25960
·
|