While in Martinique, I saw a single LED bulb that had 2 wires. The bulb had 3 switchable modes which were an Anchor light, a TriColor, and a Strobe which broadcast SOS. It switched from one mode to

Thanks Herbert, this is much helpful. From: "herbert@... [amelyachtowners]" To: amelyachtowners@... Sent: Friday, May 27, 2016 8:22 AM Subject: [Amel Yacht Owners] Re: Refit

We had a lot of work done on our santorin in Kusadasi, Turkey. As Daniel already saíd Basar and Zafar (sails and canvas) are very honest and reliable, excellent partners for boat-work and nice and

When the plastic part that transforms the rotary action of the motor into the push-pull action of the piston started to slip on our old AMFA bilge pump, Amel sent us a replacement to Fort Lauderdale

Bill, I have gotten the attention of ships with my strobe over a mile away. Last summer I was sailing and saw that a vessels closest point of approach was 13 feet. I continuously called them before

Craig, We all use the tools that make sense to us. My thinking has always been if playing my searchlight across the offending vessel’s bridge doesn’t get their attention, the strobe light is

Hi Eric, No, it has its own mounting bracket, so likely not plug and play with Aqua Signal, although it is very simple. Craig ---In amelyachtowners@..., <kimberlite@...> wrote : Hi Craig, Does that

Hi Vladimir, The rotary switch is quite small and I put it next to the switch panel with the Anchor and Tricolor switches. I'm quite sure you could use two toggles, where both on would give the

Hi Bill, Interesting point about strobe use. After a too close call with an incorrectly lit freighter off Tunisia (he was showing a 180 degree red light forward, obliterating his green and red running

Thanks, may I ask what major works you have done with them? From: "danielmfrey63@... [amelyachtowners]" To: amelyachtowners@... Sent: Thursday, May 26, 2016 11:52 PM Subject: [Amel

A clever designer of a anchor/tricolor would only need two wires. Remember that the “D” in LED stands for “diode”. Simply reverse the positive and negative to select one or the other. This

Craig, Wher did you install rotary switch? Is it possible to wire it without rotary switch but use one more tuggle switch for the strobe? On May 26, 2016 4:33 PM, "sangaris@... [amelyachtowners]"

Hi Personally I made pretty good experiences with Başar and Zafer in the Setur Marina in Kuşadası, Turkey. Very reliable and very honest. They have a good Reputation. But as always, I would check,

I dealt with Emek marine in Gocek , Turkey = Absolute Amateurs. No concept of Engineering or Quality Control… except for their solar gantry (with reservations) Dont go there. Jean-Pierre Germain SY

Hi Craig, Does that fit on the Aqua Signal series 40 Base? I was talking about that light that Amel delivered with the later Super Maramus. The Aqua signal series 30 something is plug and play

Hi Dan, We do too. You've got to fall of a few degrees so the main just fills. It stops the roll and, with some breeze, adds another knot or so of speed. If no wind or straight into the wind, then no

Hi Eric, The light is the OGM (Orca Green Marine) LXTA-SP and they use 3 conductors. A shared negative then one positive for Tricolor, a second positive for Anchor, and both positives for strobe.

Mark & the Group, I am about to do this job on SM384 while she is still in the water. If you have a moment could you please tell us how the job went? I have Raymarine ST-60 instruments too. As best I

Peter Kinek Kinowski posted in Amel Yacht Owners . Peter Kinek Kinowski May 26 at 10:45am Tussen wal en schip Wow! Net niet tussen wal en schip Like Comment Share

Hi, I got my replacement gear from Amel. Regards Danny SM 299 Ocean Pearl (departing NZ for Fiji in a couple of weeks) From: "'Bill & Judy Rouse' yahoogroups@... [amelyachtowners]" To: