Ours goes whacky when we run the microwave! Bill Kinney SM #160, Harmonie Highlands, NJ http://fetchinketch.net

Alexandre, Sorry, I' m not on the boat. 37-40 C is not our cup of tea, so we retreat to the mere 20's of London for July and August. Ian and Judy, Pen Azen, SM 302, Preveza From:

Good morning Ian, thanks for the information. Do you happened to know the size of the O Ring? I had mine measured, but not sure if this is accurate... Sincerely,

I think small debris and whirling or whipping current will cause what happened. I experienced abarnacle on one of the sensors which basically shut it down. Bill Rouse BeBe Amel 53 #387 Sent from my

Thanks Colin, yes, its all a bit strange... Glad you're enjoying the updates... I have to say there's not many cruising yachts up here this season....maybe the fear of the last cyclone or the bad

Hi Alan Your experience is exactly the same as ours. We haven't been out sailing for a few weeks now but ours did similar things over a period of a couple months (perhaps only 20 hrs sailing though)

Hi Alexandre, The first time we changed the oil in our propeller leg it was done by an Amel engineer at La Rochelle. He advised me that the O rings that came already

Hi Alan, The same happened to me in Teneriffa last year. Now my Sonic Speed is still working without repair. I think there was some current in the harbour. Hope this helps Hajo SM 150

I've researched all the msgs on this topic 'cos I thought ours had died. Yesterday when we were about to enter Suva Harbour, Fiji, the B&G boat speed instrument went crazy - down to 2 knots then up

Thanks I think the suggestion of having two o-rings is very good. I do use a lot of grease in this type of applicationa Paul on SYKerpa SM 259

Hi Paul, I would have to agree with Alexandre’s statement. I had a few things made by the turkeys in Turkey and regret it. Cheers, Jean-Pierre Germain Eleuthera, SM007

Pail, I delayed answering you because I was hoping someone had the exact answer, rather than trying to measure the O ring. But, since nobody had it, I attempted to measure it. I believe the outside

Paul, I would think twice or more about having parts made elsewhere. Even with the best intentions of the Turkey maker, the specs will not be the same. I learnt it the hard way (thinking the spare

Thankyou I had two bronze fittings made in Turkey so need to have o rings for them, and also like to have spare anyhow Paul on SYKerpa SM 259

Ho now I understand your question. I had it measure once at: 39.5 x 3 Therefore, I don’t think this is necessary to have spare as you will need to change the entire bronze fitting every 2 years and

Good morning Eric, I am not technical, so I don’t know what the washer does. I just know on the maintenance schedule it says to change it. It is in between the “oil plug” and the rest of the

Eric we do have it it's an extra seal for the oil plug. Questions remain the size of the o-ring inside the brons bussing that goes outside of the prop shaft Paul on SYKerpa SM 259

Hi Alexandre, Kimberlite does not have the washer (yellow arrow) in your photo. Where is it mounted and what does it do? Fair Winds Eric Kimberlite Amel Super Maramu #376

Hello Duane, Definitely nice to link up!!! To be honest I hired a rigger to go up there and also check the rigging, etc. The new Anchor & Tricolor lights are working! Just need a new home for my

Alexandre, Too much trouble for you! I hope you get it all worked out without too many trips to the top! I'm glad we linked up and I appreciate the Bahamas info. Duane Wanderer SM#477