We recently purchased a new supply of Racor filters and noticed that the color of the plastic on the Racor brand 2 micron filter was now beige/brown, whereas the previous Racor brand 2 micron filter

Our SM is no 302, launched in June 2000.I need another chart chip for the Geonav plotter but I am in London and the boat is in Uruguay.Some of the new Navionics cahrt chips use an updated software and

Hi, I was owner of "Kavanga" (# 69, sloop)for 10 years. We had the motorlight on top of the mast and the switch was on top of the front door leading from the saloon to the bathroom, next to the switch

My Santorin, 004, was not fitted with a "motoring" light. I understand that for some reason Amel would not fit them. I had to put on a bi-colour on the pulpit and a steaming light on the mast!

Yes, I have found this panel which has switches for all other but the steaming lights. And I doesn't seem to see them on the front mast either. Best regards Lars From:

Hi Lars, This may or not help but on our Maramu the Motoring (steaming) light, and other mast head light switches are located just above the cabin door inside the forward bulkhead between the main

Hi Gary/Joel Having read your note on new windshield. There are only two things that will delay the onset of crazing in plastics, keep the sun off(when possible) and DO NOT USE any chemicals clean

I can't seem to find the switch to the motoring lantern on my 1993 Santorin. And I can't see the lantern on the front mast... Does the Santorin have a motoring light/lantern (white) at all, where is

I do not know much about the Mango but in case it is any help write "cockpit table" in the search box and then read my messages 1781,2205 and 2490 and look in the photos section at "Changes to Bali

Hello everybody, I'm a new member of the group and owner of an Euros 41 hull #166 (built 1975). The boat doesn't have a cockpit table and I'm studying some new installation possibilities. Do anybody

Thanks Gary, Nice write-up. Have you heard anything about Desalinator making a correct circuit board that actually detects bad water? Fair winds, Eric Amel Super Maramu #376 Kimberlite _____

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the amelyachtowners group. File : /Dessalator Technical Info/REPLACING THE

The plastic screens on Bali Hai had become dull and slightly misty. We polished them with an American product and were delighted (and surprised) to see that they were perfect again and as clear as

Greetings All: I have a friend who has decided to sell his 1985 Sharki. He spent the past three years upgrading systems, sails, electronics etc. with the intent of taking an extended cruise. Business

Hello Craig And Cathrine. No particular reason for that specific date. I am really after an older boat and would consider slightly younger boats, but do not want to waste time on the plethora of not

although C Drive yachts built prior to 1998 may be Hi Fred, I don't have a boat for you but I was curious as to why you picked 1998 as your cutoff date for accepting a "C" drive? Was there a

Our hydralic lifts have ceased to work on the hatch for the engine room. Has anyone replaced these lifts with a similar lift not purchased by Amel? Amel has them, but I am fearful of what

Be aware that when you use an alternator of that power you may well need to use 2 belts to drive it. If you stay with a single belt it is best to be sure it is an "XL" belt. Also use a bracket that

Mea culpa. In this thread, I referred to Trojan T105s rated as 105 amp hours @ 6 volts. They are in fact 225Ah @ 6v, giving a capacity over 4 batteries, series & parallel, of 450Ah @ 12v, a far better

i recently noticed that the headsail furling motor is making a little more noixe in one direction than the other . it seems louder than i remember. does anyone have a suggestion as to what may be