I hope the photo comes through. It is exactly what Amel used. Fair Winds Eric Kimberlite Amel Super Maramu #376

Bill, Thanks for all the help!!!! Everyone, I ordered one and will let you know if it fits, or not. With best regards, Mark Super Maramu 2000 Hull

You have a pipe “elbow” that for some strange reason was drilled and tapped to turn it into a pipe cross. As you discovered, this is not a good idea. You need a real standard pipe “cross”

Yes, it looks modified, but I cannot tell for sure because I have the AMFA 66B, which is different from what you have. Hopefully someone else has your model. Bill Rouse BeBe Amel 53 #387 Sent from

Bill; Yes I did. This was my first picture upload which I did under a new folder. I did post a link as well. Are you able to see it?

Mohammad, Did you upload: Fitting at water pressure tank Amel 54 Updated on 12:43 AM by mshirlooFitting at water pressure tank Amel 54

Mark and everyone else, Check this out on eBay. I think this is the same plastic momentary switch that is at Budget Marine. It is US $6.99 with free US

Bill; Here's a link to the photo I just uploaded. This is the existing "non-factory" fitting that is currently installed adn needs to be

Thanks Bill for the prompt response, as always. The main issue I currently have, is the brass fitting at the supply side of the water pressure tank. Some one has just taken a 90 degree brass fitting,

David, I agree with the preemptive approach. With the handrails I am unclear on how they are fastened. Are there nuts under the headliner or??? Best, James Alton SV Sueno, Maramu

James, Great! I am glad that you found the patience. Your bow thruster may have been one of the more difficult ones with all of the layup time. So the next time someone says that they are going to do

Mohammad, Since Amel installed at least two different systems, it may help if you start with a photo of yours or the brand of the pump. It may even be possible that none of what you have is Amel

Bill, I wanted to update you to let you know that I was able to separate the motor and foot of my bow thruster using your suggestions of patience, gentle tapping and lots of penetrant. My boat

Hello every one; On our Amel 54, it appears, that the original fitting at the output of the water pressure tank was replaced with another make shift one that has now failed. This would be a brass

I think it may be possible that your bow is too low in the water...that it is overloaded. Can you completely rule out this possibility? If not try to answer these questions: Can you tell me what the

Is is possible that no one has ever had such problems on bow-thruster? May I have incorrectly fitted foam washers? Thanks for your help and greetings. enio rossi #SN122 EARENDIL ITALY

Mark, At Budget Marine, the AAA/10206 looks to be, and measures exactly the same as the Amel installed switch. It is made of marine brass and plastic and sells for about $24USD. The Trinidad Budget

Hi James, I've heard that attending to this should not be ignored, and thatthereafter regular maintenance every ? years to re-bed the railingsto minimise the chances for moisture ingress. Like the

Mark, If you only need the rubber cover of the push button try this ( 4,50 Euro) http://www.watski.de/Schalter-und-Schaltpaneele-111uy/1/n Hajo SM 150 Serafine Carloforte San Pietro Sardinien Von

Yep! Time to crank up the SailRite and make a cover. With best regards, Mark Super Maramu 2000 Hull #275 www.creampuff.us Currently cruising: Tampa Bay for hurricane season