Likewise, I spent the big bucks and went with HP portable printer. It's so convenient to just drag it out of the drawer, turn it on and print via Bluetooth from the laptop or even the phones.

Hi Bill and Alexandre, Just to say that with your kind assistance our chain counter now works again. However, the replacement sensor has changed once more. IFM no longer make IB5124 which was

HI Rafael, My compressors on Kimberlite have been working fine on 60 hertz for the last 15 summers and much of the winter in the Caribbean. Unfortunately I have tried to use a number of

Rafael, I would like to help. It sounds like you have had a bad (and warm) day. Who are you going to believe? Amel manuals for Climma Compact 9 state either 50 or 60 hertz. I am going to believe

It will probably be enough to change the capacitatiors to the one that can handle both 50 and 60 Hz. Regards Ann-Sofie S/Y Lady Annila SM232, 1998 Skickades från E-post för Windows 10

Quick reply on the frequency. For the Dishwasher, washing machine, microwave, scuba compressor and water maker it has to be 50 Hz - therefore even thought the air conditioning says 50 hertz it can be

The air conditioner of the bow doesn´t work. When it turn on, the fuses fall all over the boat. The air conditioning technician pointed out that the bow equipment, a Climma, Compact 9 EH, has bad

I would like to thank through this group to Erik Kimberlite for their help to our first navigation in St Martin, with my family. Their willingness and willingness to teach were very important to

Hello Soraya; We have the HP ML150 portable printer on board. It is pretty small, battery operated (rechargeable), light and can print at decent speeds and blue tooth. We typically just take it out,

Soraya We have had the same printer on board for the last 8years. It has been and is very reliable.Extremely useful for sharing info with other boaters and for printing out infoand notes when

We put every packing ( noodles, flour, sugar, etc.) after we bought it for a few minutes in the microwave. I think that will kill everything. Regards Hajo and Julia SY Serafine, SM 150 Von meinem iPad

Good morning Soraya, So I can not recommend a specific printer, but in my opinion, the printer should at least accept 50 and 60 Hz current. Best is also 110/220 volt (or 220 volt since the boat is in

We have an HP Deskjet 2540 wireless printer scanner on board and it is invaluable for scanning documents to send to Customs in the next ports, printing out hard copies of registration etc for customs,

The Dessalator water maker switches from green to yellow when I start the engine and the rpm's go above 1000. The water quality is still measureable good (around 200 ppm) and the charging current is

I wouldn’t do without a printer onboard, mostly because of my job.😊 I have had a HP Laser worked perfect until there where no drivers for it anymore … Changed to a compact

Dear Amelians, Contemplating getting a printer onboard... From experience: - would you say that is something useful to have onboard? - Any suggestions or recommendations of models both compact

Dear Amelians, Has anyone had to replace the light of their Plastimo Magnetic Compass? - is that done through the front or back of the compass? - do you know what bulb is required? With thanks

Alex, it is common for bugs' eggs to hatch inside dried pasta, especially in the tropics. Get yourself a good vacuum sealer machine and vacuum-seal pasta and all other grains, cereals and flours that

Hi Thomas, The MPPT only gets warm when working hard, not hot. We do get heat from the dump resistors of the wind generator when it is working hard (not often), but we have a heat shield to protect

Thanks Alan, that's a good idea; we have the same locker there. Hopefully the wiring is rather simple to manage. Do you find the regulator produces a lot of heat? Cheers Thomas -- GARULFO Amel 54